Monitor Audio Bronze 300 7G handleiding
Handleiding
Je bekijkt pagina 4 van 13
4 5
Bronze 50 7G & Bronze Centre 7G feet
The Bronze 50 7G and Bronze Centre 7G come
with self adhesive rubber feet in the packaging.
These should be placed on the underside of
the cabinet in the corners when placing the
speakers on a shelf or when using third party
stands for the speakers. This helps to isolate
the loudspeaker and reduce the chances of it
moving.
Bronze 300 7G outrigger feet
The feet and outriggers are supplied assembled for use on non-carpeted, wooden/hard loors
or where spikes are inappropriate. All that is required is to ix them to the speaker base using
the supplied bolts and hex keys.
If the speaker is being installed on a carpeted loor, screw the spike (A) into the foot and ‘out-
rigger’ assembly.
Note: Please ensure there are no hidden wires under the carpet that could be damaged
by the spikes.
M10
X 1.25 mm
M4
(A) M5
Spikes & feet
Levelling the speaker (Bronze 300 7G)
You can check that the speaker is level on all sides by using a spirit level (not supplied). If it’s
slightly o-level, unscrew the foot at the lowest point and check again. Continue this process
until the cabinet is fully level. Use the locking nuts on each foot to ix the feet in place and to
stop any unwanted vibrations.
Bekijk gratis de handleiding van Monitor Audio Bronze 300 7G, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Monitor Audio |
| Model | Bronze 300 7G |
| Categorie | Speaker |
| Taal | Nederlands |
| Grootte | 970 MB |
