Mitsubishi MLZ-KP25-50VG handleiding
Handleiding
Je bekijkt pagina 6 van 28
EN-5
● OPERATING INSTRUCTIONS ●
Selecting Operation Modes
1
Press
to start the operation.
2
Press to select operation mode. Each press
changes mode in the following order:
3
Press or to set the temperature.
Each press raises or lowers the temperature by 1°C.
Press
to stop the operation.
(Auto) (Cool) (Dry) (Heat) (Fan)
Note :
Operation indicator lamp
The operation indicator lamp shows the operation state of the unit.
Indication Operation state Room temperature
The unit is operating to reach the set
temperature
About 2°C or more away
from set temperature
The room temperature is approach-
ing the set temperature
About 1 to 2°C from set
temperature
Standby mode (Refer to multi system
operation)
—
Lit Blinking
Not lit
Multi system operation
Two or more indoor units can be operated by one outdoor unit. When several
indoor units are operated simultaneously, cooling operation and heating opera-
tion cannot be done at the same time. When cool mode is selected with one
unit and heating operation with another or vice versa, the unit operated later
becomes standby mode.
Water may condense when heat mode is operated with other units within
3 hours after cooling operation/dry operation is stopped.
To prevent water condensation, perform heating operation with temperature
set to 16°C for about 30 minutes after cooling operation/dry operation.
Theunitselectstheoperationmodeaccordingtothedierencebetween
the room temperature and the set temperature. During auto mode, the unit
changesmode(coolmode↔heatmode)whentheroomtemperatureisabout
2°C away from the set temperature for more than 15 minutes.
Note :
During multi system operation, the unit may not be able to switch opera-
tion mode between cool mode and heat mode. In this case, the indoor
unitbecomesstandbymode(RefertotableofOperationindicatorlamp).
Auto mode (auto change over)
Cool mode
Enjoy cool air at your desired temperature.
Note :
Donotoperatecoolmodeatlowoutsidetemperature(lessthan-10°C).
Water condensed in the unit may drip and wet or damage furniture, etc.
Dry mode
Heat mode
Fan mode
Dehumidify your room. The room may be cooled slightly.
Temperature cannot be set during dry mode.
Enjoy warm air at your desired temperature.
Circulate the air in your room.
Temperature cannot be set during fan mode.
Note :
After cool mode/dry mode operation, it is recommended to operate in the
fan mode to dry inside the indoor unit.
Bekijk gratis de handleiding van Mitsubishi MLZ-KP25-50VG, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Mitsubishi |
| Model | MLZ-KP25-50VG |
| Categorie | Airco |
| Taal | Nederlands |
| Grootte | 6524 MB |
