Mitsubishi MLZ-KP25-50VG handleiding
Handleiding
Je bekijkt pagina 4 van 28
EN-3
● OPERATING INSTRUCTIONS ●
Before operation: Insert the power supply plug into the power outlet and/or turn the breaker on.
Preparation Before Operation
Installing the remote controller batteries
1.
Remove the front lid.
2.
Insert the negative
pole of AAA alkaline
batteriesrst.
3.
Install the front lid.
4.
Press the reset
button.
Setting current time
1.
Press the clock button.
4.
Press the clock button
again.
3.
Press the day button
to set the day.
Note:
• Make sure the polarity of the batteries is correct.
• Do not use manganese batteries and leaking batteries. The remote controller
could malfunction.
• Do not use rechargeable batteries.
• The battery replacement indicator lights up when the battery is running low.
In about 7 days after the indicator starts lights up, the remote controller stops
working.
• Replace all batteries with new ones of the same type.
• Batteries can be used for approximately 1 year. However, batteries with ex-
pired shelf lives last shorter.
• Press
button gently using a thin instrument.
If the
button is not pressed, the remote controller may not operate cor-
rectly.
Note:
• Press
button gently using a thin instrument.
2.
Press either the time button
or the timer buttons to set the
time.
Each press increases/decreas-
es the time by 1 minute (10
minuteswhenpressedlonger).
Note:
How to set remote controller exclusively for a particular indoor unit
A maximum of 4 indoor units with wireless remote controllers can be used in
a room.
To operate the indoor units individually with each remote controller, assign a
number to each remote controller according to the number of the indoor unit.
This setting can be set only when all the following conditions are met:
• Theremotecontrollerispoweredo.
(1)Holddown
button on the remote controller for 2 seconds to enter the
pairing mode.
(2)Press
button again and assign a number to each remote controller.
Each press of
buttonadvancesthenumberinthefollowingorder:1→
2→3→4.
(3)Press button to complete the pairing setting.
Afteryouturnthebreakeron,theremotecontrollerthatrstsendsasignal
to an indoor unit will be regarded as the remote controller for the indoor unit.
Once they are set, the indoor unit will only receive the signal from the as-
signed remote controller afterwards.
Thesettingindoorunitwillbecancelled,ifthebreakeristurnedoorthe
power supply is shut down.
Bekijk gratis de handleiding van Mitsubishi MLZ-KP25-50VG, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Mitsubishi |
| Model | MLZ-KP25-50VG |
| Categorie | Airco |
| Taal | Nederlands |
| Grootte | 6524 MB |
