Handleiding
Je bekijkt pagina 11 van 92
EN
11
batteries whenever you anticipate that the remote control will not be used for an extended
period.
• The batteries (battery pack or batteries installed) shall not be exposed to excessive heat
such as sunshine, fire or the like.
CAUTION:
• It may result in an explosion if batteries are replaced incorrectly.
• Only replace batteries with the same or equivalent type.
2.2. Connection and Setup
2.2.1. Cable Installation
Please read the relevant content in “Notice for Maintenance and Safety” carefully before the
installation and use.
1. Take out the TV from the package and put it in a drafty and at place.
Note:
• When you plug or unplug the TV, computer or other equipments, you must make sure that
the AC power has been already shut down; when unplugging the power cable or signal cable,
please hold the plug (the insulated part), do not draw the body of the cable.
2. The RF output terminal can be connected with the RF input port of the TV.
3. The output AV terminal of DVD can be connected with the AV input port of the TV through
AV cable.
Note:
• Component and AV cannot be used at same time as they share one audio channel.
4. The output Component (YPbPr) terminal of DVD can be connected with the Component
(YPbPr) input port of the TV through AV cable.
5. Connect one end of the VGA cable with the VGA port on computer, connect the other end
of the VGA cable with the VGA port on the TV, and tighten the bolts clockwise on each end of
VGA cable.
Note:
• While connecting the 15-pin VGA, please do not insert the plug overexertedly, for fear the
pin might be broken.
6. Connect one end of the HDMI cable with HDMI output port, connect the other end of the
HDMI cable with the HDMI port on the TV.
Note:
• While connecting the HDMI, please aim at carefully, do not insert overexertedly, for fear the
pin might be broken.
7. Connect SCART socket input or output from an external device to these jacks.
8. Send the TV’s audio signal to external audio equipment via the Digital Audio Output port.
9. Check and make sure that all AV cables are connected with the corresponding ports cor-
rectly.
10. Connect the AC power cable with 100-240V~ power supply.
Bekijk gratis de handleiding van Mitsai 32DCG160014, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Mitsai |
| Model | 32DCG160014 |
| Categorie | Televisie |
| Taal | Nederlands |
| Grootte | 9013 MB |
