Mirpol Bise handleiding
Handleiding
Je bekijkt pagina 10 van 11
10 BISE COLUMNPL / EN
Operation
The fan can be operated manually by the touch controls
located on top of the fan or by remote control.
logo size: L? mm X H? mm
Logo color: Black?
POWER
Turn the FAN on by pressing the POWER
1
button. The
blue LED power decorative light around POWER button will
stay on and the LED display will show the fan is operating in
low/middle/high(1/2/3) speed, To turn the fan off press the
‘POWER’ button again.
SPEED
You can adjust the fan speed to the desired level: Low,
Middle or High by pressing the SPEED
2
button. The speed
setting (1/2/3) is displayed on the middle of LED screen .
MODE
Pressing the MODE
3
button will set the FAN into
NORMAL, NATURAL or SLEEP mode. The chosen MODE is
displayed on left side of the LED display:
• Normal mode: the fan operates in a conventional way at
the selected speed Low, Middle or High.
• Natural mode : The fan will operate through
continuous cycles: Low, Middle, High and Off.
• Sleep mode : The fan will operate through
continuous cycles: Low, Middle, High and Off. The white
LED power decorative light around ‘POWER’ button will
off after 30 second . The LED display’s brightness will
decrease 50% after 30 seconds’ no operation.
TIMER
The fan is equipped with a timer that allows you to set from
1 hour to 8 hours, increased by 1 hours intervals. Press the
timer
4
button set the timer from 1 to 8. The screen will
display the set speed and set time in turn every 5 second.
OSCILATION
Pressing the OSC
5
button will start the oscillation
function, press again to stop this function.
Decommissioning
Warning against electric voltage
Do not touch the mains plug with wet or damp hands.
• Set the power switch to 0 / OFF position.
• Disconnect the device by pulling the power plug.
• Clean the device as described in the chapter
„Maintenance”.
• Store the device in accordance with the chapter
„Transport and storage”.
Errors and faults
Warning against electric voltage
Activities that require opening the device may only
be performed by an authorized service center or by
Mirpol.
The correct operation of the device has been checked many
times as part of the production process.
If there are any faults, check the list below:
The device does not start up:
• Check the mains connection.
• Check that the mains plug or cord is not damaged.
• Check the electrical fuses on the side power.
The device does not work properly despite carrying out all
the checks:
Contact service. Deliver the device for repair to an
authorized Mirpol service center.
Maintenance
Activities before starting maintenance
Warning against electric voltage
Do not touch the mains plug with wet or damp hands.
Disconnect the power supply.
Warning against electric voltage
Activities that require opening the device may only
be performed by an authorized service center or by
Mirpol.
Cleaning the housing
Warning against electric voltage
Never immerse the unit in water, no let water drip
into the unit.
Clean the outside of the unit with a damp cloth and then dry
it with a dry cloth.
CAUTION: Do not use petrol, benzene, solvents, harsh
cleaners, etc., as these may damage the heater.
NEVER USE ALCOHOL OR SOLVENTS.
2
3
4 5
1
2 5
4 3
1
Bekijk gratis de handleiding van Mirpol Bise, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Mirpol |
| Model | Bise |
| Categorie | Ventilator |
| Taal | Nederlands |
| Grootte | 2241 MB |