Mirage 741101D handleiding
Handleiding
Je bekijkt pagina 6 van 24
6
Mirage
®
Drop-in Induction Warmers and Rethermalizers Operator’s Manual
TROUBLESHOOTING
Problem Might be Caused By Course of Action
The equipment is on, but not heating
and the display is flashing.
The inset is not a Vollrath induction-ready
inset or is the wrong size Vollrath induction-
ready inset.
Replace the inset with the correct size Vollrath induction-ready
inset for the equipment. Vollrath induction-ready insets are
stamped “Induction Ready.” Reset the equipment by turning it
OFF and then ON.
Trouble with the electrical connection is
causing low input voltage.
Make sure the plug is fully inserted into an electrical outlet that
matches the rating on the equipment’s nameplate.
Make sure the electrical circuit is not overloaded.
Alarm is sounding. An error. See the Display Messages in the table below.
The equipment suddenly stopped
working.
The equipment may be too close to an exter-
nal heat source or the air intake may be
restricted.
Relocate the equipment away from external heat sources. Clear
any obstructions to the air intake. Contact Vollrath Technical
Services if the problem persists.
The inset may be too hot.
Remove the inset. Allow the inset and equipment to cool before
resuming use. Contact Vollrath Technical Services if the prob-
lem persists.
Display
Message Cause Course of Action
Bad Pan
The inset is not a Vollrath induction-ready inset or is the wrong size
Vollrath induction-ready inset.
Replace the inset with the correct size Vollrath induction-ready
inset for the equipment. Vollrath induction-ready insets are
stamped “Induction Ready.” Reset the equipment by turning it
OFF and then ON.
HOT
If the equipment is turned off, this is normal. It indicates the equip-
ment is still hot.
Allow the equipment to cool (about 5-10 minutes) before clean-
ing.
If the equipment is in use, the inset may be too hot.
Remove the inset. Allow the inset and equipment to cool before
resuming use. Do not place excessively hot food into the inset.
Do not an place excessively hot inset into the equipment. Con-
tact Vollrath Technical Services if the problem persists.
F-2 The inset may be too hot.
Remove the inset. Allow the inset and equipment to cool before
resuming use. Do not place excessively hot food into the inset.
Do not an place excessively hot inset into the equipment. Con-
tact Vollrath Technical Services if the problem persists.
F-1
The equipment may have overheated.
Relocate the equipment away from external heat sources. Clear
any obstructions to the air intake. Contact Vollrath Technical
Services if the problem persists.
F-8
Other error
codes
Internal error. Contact Vollrath Technical Services.
Bekijk gratis de handleiding van Mirage 741101D, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Mirage |
| Model | 741101D |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 3994 MB |
