Handleiding
Je bekijkt pagina 2 van 12
2 Mirage
®
Cadet Countertop Induction Range Operator’s Manual
COOKWARE REQUIREMENTS
Note: Cookware with inferior construction or material may not perform
well. Cookware with a larger base diameter can be used, however only
the area of the cookware above the induction coil will heat. The more
cookware extends past the coil, the more the overall performance will
be reduced.
FCC STATEMENT
This equipment has been tested and found to comply with Part 18 of
FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment and receiver
• Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected
• Consult the dealer or an experienced radio/TV technician for help
To assure continued compliance, any changes or modifications not
expressly approved by the party Responsible for compliance could void
the user’s authority to operate this equipment.
CLEARANCE AND ENVIRONMENT REQUIREMENTS
This unit is not designed to be enclosed or built into any area. Sufficient
airflow must be allowed around the unit. Blocking the airflow could
cause the unit to overheat.
• Rear of the range to any surrounding surface: 4" (10 cm)
• Bottom of the range to any surrounding surface: ¹⁄₂" (2 cm)
• Indoor use only.
• Do not place the equipment on or near heat-producing equipment.
FEATURES AND CONTROLS
Compatible
Incompatible
• Flat base 4¾" to 10¼"
(12.1 to 26 cm) in diameter
• Ferrous stainless steel, iron,
cast iron
• Base is not flat
• Base is less than 4¾" (12.1 cm)
in diameter
• Pottery, glass, aluminum,
bronze or copper cookware
• Metal disk on bottom of pan
NOTICE: Equipment Damage Hazard
Not intended for use with aluminum pans with a metal disk on
the bottom. Under high heat, the metal disk will separate from
the pan. These pans may damage your unit and void your
warranty.
4¾" to 10¼"
less than 4¾"
A On/Off Button. Press to turn unit on. The Power LED and the three digit
Display panel will illuminate when switched on.
B Power/Temp Button. Press to toggle between Power and Temperature
control, and Fahrenheit and Celsius.
C ºC LED Light. Illuminates when the temperature in being displayed in
degrees Centigrade.
D ºF LED Light. Illuminates when the temperature in being displayed in
degrees Fahrenheit.
E Power On LED Light. Illuminates when the unit is on. This light will
blink until induction-ready cookware is detected. Once induction
cookware is detected the light will remain on.
F Display Panel. Displays the power level, temperature, timer time or an
error code.
G Down Button. Press to decrease the power level, temperature or time,
H Up Button. Press to increase the power level, temperature or time,
I Timer Button. Press to start the timer function.
Power
A
DE
C GB F H I
Bekijk gratis de handleiding van Mirage 59300, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Mirage |
| Model | 59300 |
| Categorie | Fornuis |
| Taal | Nederlands |
| Grootte | 1987 MB |
