Handleiding
Je bekijkt pagina 16 van 76
16
ENGLISH
5.2.2. Volume
You may set the desired volume to listen to your baby using the raise / lower volume buttons (2
and 3) on the front of the parent unit.
Selecting the volume level (9 levels) will not affect the sensitivity of your baby monitor, which features
factory congurations, but only the volume at which you will hear the sounds on the parent unit.
5.2.3. Charge and low battery indicator
The On/Off and charging LED indicator (4) in Parents Unit works as an indicator of the charging
process:
If the parents’ unit is switched off and is plugged in to charge via the mains electricity supply:
· The On/Off and charge LED indicator (4) will ash in red while the parents unit batteries are charging.
· When the batteries are fully charged this LED indicator (4) will light up red.
If the parents’ unit is switched on in low radiation mode (LOW) and is plugged in to charge via
the mains electricity supply:
· The On/Off and charge LED indicator (4) will ash in green while the parents unit batteries are charging.
· When the batteries are fully charged this LED indicator (4) will light up green.
If the parents’ unit is switched on in zero emissions mode (ZERO) and is plugged into the mains
electricity supply:
· The On/Off and charge LED indicator (4) will ash in yellow and red while the parents unit
batteries are charging.
· When the batteries are fully charged this LED indicator (4) will light up yellow.
The approximate charging time for the parent unit batteries is around 5 to 8 hours, depending on
the battery charge level at the onset of the process.
When the batteries are fully charged the average life of the parent unit is around 6 to 7 hours and
will depend on the listening / standby cycles. The maximum battery life will be around 10 to 12
hours in the event the baby unit remains in a silent environment for most of the time.
When the battery level of the parent unit is low, the parent unit will emit a warning beep every 30
seconds and the LED on / off and charge indicator will ash red. When this occurs, charge the
parent unit. You may continue to use the baby monitor while the parent unit is charging.
5.2.4. Paging (searching for the parent unit)
This option serves to nd the parent unit when it cannot be found. It is also very useful when one
of the parents is in the baby´s room and needs to contact the other parent.
Press the night light / parent unit search button (11) on the baby unit for 3 seconds. The parent unit will
emit a three-tone beep which you can deactivate by pressing any of the buttons on the parent unit.
5.2.5. Night light
The baby unit features a night light (12) which emits a soft glow, providing your baby with comfort
and enabling him / her to see in a dark room.
To turn the night light on or off press the night light / parent unit search button (11). Remember
that the night light is controlled by pressing the button (11) for a short time.
5.2.6. Mode: zero emissions (ZERO) and low radiation (LOW)
The baby unit features special transmission technology known as Zero Emissions. When the
baby unit is in standby mode and no sound is detected in the room, this unit emits no radiation.
The mode used by the baby unit may be Low Radiation or Zero Emissions. It is possible to
choose the communication mode between the two units by making 3 short presses on the ON /
OFF button (1) of the parent unit.
Bekijk gratis de handleiding van Miniland Digitalk Easy 89474, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Miniland |
| Model | Digitalk Easy 89474 |
| Categorie | Babyfoon |
| Taal | Nederlands |
| Grootte | 7526 MB |
