Handleiding
Je bekijkt pagina 14 van 76
14
ENGLISH
3.4. PRIOR TO USE
Choosing the right place
· Place the baby unit away from televisions and TV repeaters and radios. The signals generated
by these devices may cause noises or even sounds which are retransmitted on the baby unit. If
this occurs you will need to place the baby unit somewhere else.
· The baby unit should be placed at least 3 metres from the baby´s cot and on a at surface. The
baby unit should never be placed in the cot, on the bed or playground. Ensure the unit and cables
are all out of the reach of the baby and small children.
· Place the baby unit where the air is circulating freely, and never on eiderdowns or blankets or
on the edge of a closet, shelf, etc
Place the baby monitor away from sources of heat such as radiators, chimneys, kitchens and
direct sunlight.
4. CHARACTERISTICS OF THE PRODUCT
4.1. FEATURES AND CONTROLS OF THE PARENT UNIT (Figure 1)
1. On / Off button
2. Raise volume button
3. Lower volume button
4. On/Off and charge LED indicator: the permanent green light indicates the device is on, while
the ashing green light indicates the batteries are charging.
5. LED low sound level indicator: remains off when no sound is detected from the baby unit, and
ashes red when a sound is detected (when it is low) in the baby´s room.
6. LED high sound level indicator: remains off when the sound level detected in the baby´s room
is low and ashes red when the baby unit detects a loud noise.
7. Neck strap opening
8. Battery compartment (2 x AAA 1.2V 800 mAh Ni-MH rechargeable)
9. USB-C power connector
4.2. FEATURES AND CONTROLS OF THE BABY UNIT (Figure 2)
10. On / Off button
11. Night light button (short touch) / parent unit search (long touch).
12. LED On / night light indicator: lights up green when the baby unit is on and emits a more
powerful white light when the night light is turned on.
13. Switch VOX (LOW / HIGH)
14. USB-C power connector
5. INSTRUCTIONS FOR USE
5.1. PRIOR TO USE: CONNECTION TO THE POWER AND USE OF THE BATTERIES
The parent unit:
The baby unit of this baby monitor can work with non-rechargeable alkaline batteries (not
included) or connected to the mains power supply.
If you want to connect your baby monitor to the mains power supply, connect the USB connector
part of the charging cable supplied to the USB socket of a suitable power adaptor and the other
end to the baby unit. Then connect the adaptor to the mains.
If you want to use the baby unit with batteries instead, remove the compartment cover (20), insert
3 AAA 1.5V alkaline batteries (not included) and close it again.
Remember these batteries cannot be recharged as in the parents’ unit, but must be replaced
with new ones when they are worn out.We recommend using the batteries in the parent unit to
enable you to hear the baby unit from anywhere (within the range of the signal of the apparatus).
- The rechargeable batteries should be charged for 16 hours before use for the rst time or when
Bekijk gratis de handleiding van Miniland Digitalk Easy 89474, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Miniland |
| Model | Digitalk Easy 89474 |
| Categorie | Babyfoon |
| Taal | Nederlands |
| Grootte | 7526 MB |
