Miniland Digimonitor Easy 89505 handleiding

Babyfoon

Miniland

44 pagina's

PDF beschikbaar

Handleiding

ENGLISH

PROBLEM POSSIBLE CAUSE SOLUTION

Only black and white images are displayed.

Check whether the camera is in night

vision/infrared mode.

In order to view the images in colour, increase

the level of light in the room the camera is in or

check there is nothing covering the camera´s

light sensor (II).

The camera is not transmitting.

The camera has not been turned on.

Press the on / off button on the camera (I)

and keep pressing for 2 seconds.

Camera: power adapter not plugged in. Plug in the power adapter.

VOX mode or standby mode is activated.

To view the monitored area continuously,

switch off the VOX mode or power saving

mode on the monitor.

It is not possible to hear the baby on the

parental unit.

The volume setting of the parental unit is

too low.

Set the volume at the highest level. Check

section 5.2.2.

Interference or poor reception.

Other electronic devices may be interfering

with the signal.

Move them away from the device.

The camera and monitor may be too far apart.

Extend the antenna (15) of the monitor, and

in case it is still out of range move the monitor

closer to the camera.

The battery charge level may be too low. Plug in the power adapter.

The camera or monitor may be too close to

many metal objects.

Move them away from the device.

If the baby unit has lost connection with the

parental unit.

The camera and monitor may be too far apart.

Extend the monitor antenna, and in case it is

still out of range move the monitor closer to

the camera.

Connection between the two units is

momentarily lost.

Restore the units by disconnecting them from

the power supply.

Wait about 15 seconds before reconnecting

them.

Allow one minute for the baby unit and the

parent unit to synchronize.

The connection between the two units

is lost.

Pair the camera and monitor again.See

section 5.2.10.1.1.

8. TECHNICAL SPECIFICATIONS

Frequency 2.4GHz FHSS

Operating Range 240m (straight line and open space)

Nº of conﬁgurable channels 2

Power (parent unit) Input: 100-240 V CA - 50/60 Hz

Power (parent unit) Output: 5 V – 1A

Rechargeable battery for sasasmonitor 3.7V 1200 mAh

Power (baby unit) Input: 100-240 V CA - 50/60 Hz

Power (baby unit) Output: 5 V – 1A

Operating time with battery fully charged (parent unit) Approximately 8 hours

LCD Screen size 3.5”

9. PRODUCT DISPOSAL INFORMATION

· Remember to dispose of the product responsibly.

· Do not mix products bearing the crossed -out bin symbol with your

general household waste.

· For the correct collection and treatment of these products take them

to the collection points designated by your local authority. Alternatively

contact the retailer who sold you the product.

Hereby, Miniland S. A. declares that this “89505

digimonitor 3.5" easy is in compliance with

the essential requirements and other relevant

provisions of Directive 2014/53/UE.

Bekijk gratis de handleiding van Miniland Digimonitor Easy 89505, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.