Miniland Digimonitor 89179 handleiding
Handleiding
Je bekijkt pagina 14 van 60
14
ENGLISH
3. Using the UP key or DOWN key, select the transmission level desired: HIGH or LOW.
4. Conrm the selection pressing the key.
5. Press the Menu/Back key to return to the main screen.
6. TRANSMISSION LEVEL icon (E) will be displayed at the top of the LCD screen.
5.2.4. CHOOSING THE CAMERA
This product is designed to allow the observation of different areas with up to 4 cameras. To
choose the camera you want to see, follow the next steps:
1. Press the Menu/Back key and the menu icon will pop up.
2. Press the UP or DOWN key until the camera icon is highlighted then press OK key
to enter into the sub-menu.
3. Press UP /DOWN key to select the desired camera to view (Camera 1, camera 2,
camera 3, camera 4 or scan mode).
4. Press key go to selected cam.
Note 1: You will only be able to select the cameras that have already been paired with the
monitor.
Note 2: There is a faster way to change the camera you are viewing. Directly press key to
cycle through paired cameras: CAM1 / CAM2 / CAM3 / CAM4 / SCAN MODE.
5.2.5. SCAN MODE
This function automatically cycles through your paired camera channels to display each camera
for 12 seconds. This function can be used only when you have more than 1 camera unit paired.
To enter in this mode:
1. Press the Menu/Back key and the menu will pop up.
2. Press the UP key or DOWN key until the camera icon is highlighted then press
key enter into the sub-menu.
3. Press UP /DOWN key to select the scan camera icon .
4. Press key.
Note 1: When one of the cameras is out of range or is not switch on, the monitor will warn you
and the Scan Mode will stop.
Note 2: The Scan mode can be turned on or off by pressing the button while viewing the
main screen.
5.2.6. ADD CAMERA AND PAIRING
The pairing between the monitor and the camera will be done under two circumstances:
- If you want to add an additional camera.
This product is designed to allow the observation of different areas with up to 4 cameras.
- If the CONTROL monitor and the camera are not paired.
The monitor and the original camera leave the factory with channel 1 programmed, nonetheless,
if for some reason, they are not, you can link them manually following the steps indicated below.
To pair the camera and the monitor follow the next steps:
1. Press the MENU/Back key and the menu will pop up.
2. Press UP key or DOWN key to select ADD camera icon then press key enter
into the sub-menu.
3. Press UP /DOWN key to select the desired camera to add.
4. Press key to search for a camera unit. The power LED indicator (2) will begin to ash in
green.
5. While the LED indicator is ashing, press the link button on the camera (VI).
6. Once paired, the LED indicator will stop ashing and the image of the camera will show
immediately on the monitor unit screen.
7. If unsuccessful, please repeat above steps.
For various reasons you may lose the connection between the monitor and a camera which is
already connected. Should this be the case, repeat the process explained above to connect the
Bekijk gratis de handleiding van Miniland Digimonitor 89179, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Miniland |
| Model | Digimonitor 89179 |
| Categorie | Bewakingscamera |
| Taal | Nederlands |
| Grootte | 6432 MB |
