Handleiding
Je bekijkt pagina 41 van 72
Cleaning and care
41
If a drying programme is interrupted
with a fault message after the clean
plinth filter has been refitted, the plinth
filter was too wet when it was refitted.
Carefully squeeze the water out of the
plinth filter again. Leave the plinth filter
to air-dry.
If a fault occurs again despite this, it
may be due to stubborn residue from
washing substances. Reactivate the
plinth filter in the washing machine.
See “Problem solving guide – Reactiv-
ating the plinth filter”.
Blockages caused by a damaged
or worn filter.
The heat exchanger becomes
blocked and damage may occur.
Check the plinth filter following the
instructions provided in “Problem
solving guide – Replacing the plinth
filter”. Replace the plinth filter if ne-
cessary.
Use a damp cloth to remove any fluff
from the handle.
Fit the plinth filter back on the handle.
Make sure it is the correct way round.
Push the plinth filter in completely.
This will push in the right-hand guide pin
at the same time.
Pouring out the cleaning water
To catch any particles or fluff, pour the
contents of the bowl or bucket
through a filter (e.g. coffee filter).
Dispose of the filter with your house-
hold waste.
Cleaning the plinth filter access panel
Use a damp cloth to remove any fluff.
Make sure that you do not damage
the rubber seal when doing this.
Close the heat exchanger access
panel.
Bekijk gratis de handleiding van Miele TEA525WP, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Miele |
| Model | TEA525WP |
| Categorie | Wasdroger |
| Taal | Nederlands |
| Grootte | 7786 MB |
