Miele Guard L1 Cat & Dog handleiding
Handleiding
Je bekijkt pagina 41 van 132
en
41
Adjusting the floorhead (Fig. 08 + 09)
Depending on the model, your vacuum
cleaner will be fitted as standard with
one of the floorheads illustrated.
Please observe the flooring manufac-
turer’s cleaning and care instructions.
Clean hard flooring which is not sus-
ceptible to scratching, as well as floor-
ing with gaps or deep crevices in it, with
the brush protruding:
Press the foot switch.
Vacuum carpets and rugs with the brush
retracted:
Press the foot switch.
If the suction power of the floorhead
seems too high, reduce it until the
floorhead is easier to manoeuvre (see
“Selecting the suction power”).
Vacuuming staircases (Fig. 10)
Risk of injury caused by falling
vacuum cleaner.
You or others may be injured if the
vacuum cleaner should fall from the
stairs.
When vacuuming stairs, it is best to
start at the bottom of the stairs and
move upwards.
The adjustable floorhead can also be
used for vacuuming the stairs.
Unwinding the mains cable (Fig. 11)
Pull the mains cable out to the re-
quired length.
Insert the power plug into the socket.
Risk of damage due to overheat-
ing.
The mains cable may overheat after a
long period of use.
If vacuuming for longer than
30minutes, the cable must be pulled
out all the way.
Rewinding the mains cable (Fig. 12)
Remove the plug from the socket.
Step briefly on the cable rewind foot
switch.
The cable will then retract itself fully into
the vacuum cleaner.
You can interrupt the cable rewind at
any point.
Give the cable a short pull while re-
winding.
Switching on and off (Fig. 13)
Press the On/Off foot switch .
Selecting the suction power (Fig. 14)
The suction power can be regulated to
suit the type of flooring being cleaned.
Reducing the suction power reduces the
amount of effort required to manoeuvre
the floorhead.
The power level selected will light up.
The first time the vacuum cleaner is
switched on, the highest power level
will be selected automatically.
After that, the vacuum cleaner will
switch on at the power level which was
used previously.
Press the + foot switch to select a
higher suction power level.
Press the - foot switch to select a
lower suction power level.
Bekijk gratis de handleiding van Miele Guard L1 Cat & Dog, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Miele |
| Model | Guard L1 Cat & Dog |
| Categorie | Stofzuiger |
| Taal | Nederlands |
| Grootte | 14207 MB |
