Midea MLTW09M1BWW handleiding
Handleiding
Je bekijkt pagina 9 van 32
Install Your Washer
Step 5: Leveling your washer
loosen lock
Adjustable legs
See if the washer is level by checking the position of the tub or using a leveling
gauge.
1. Slide the washer into position.
2. Open the lid of the washer, and pour
the water into the tub to just below
the pulsator level.
3. If the washer is level, the pulsator is
positioned at the center of the washer
as shown in the figure above right.
If not, level your washer by turning
the front leveling feet clockwise or
counterclockwise as necessary.
Leveling gauge
Plug the power cord into a 3-prong, well grounded 120Volt
60Hz approved electrical outlet protected by a 15-amp fuse
or comparable circuit breaker.
Your washer is grounded through the third prong of the power
cord when plugged into a 3-prong grounded electrical outlet.
Step 6: Powering your washer
Step 7: Running a test cycle
1. Load about 3.5 pounds of laundry into the tub.
2. Press the Power button to turn on your washer.
3. Select the Rinse+Spin cycle as instruction on page 19.
4. Press the Start/Pause button to start the test cycle.
5. The washer should not rock or vibrate excessively when water is supplied or
when washing or spinning, and should drain well during the spin cycle.
If water leaks while water is being supplied or drained, check the water
connections.
If the washer rocks and vibrates excessively, level your washer again.
Step 8: Storing your washer
If you want to store your washer at another location, unplug it, drain any remaining
water from the drain pipe and hook the pipe onto the back of the washer.
Disconnect the water inlet hoses from the faucets and move washer to new location.
Install Your Washer
Installation Instructions Installation Instructions
There is ONLY ONE adjustable leg
as right figure on this washer.
Position the other end of the drain hose. It can be positioned in three ways.
A. Over the edge of a wash basin.
Secure the g uid e to the side of
the basin wall with a hook or to
t h e t a p w i t h a p i e c e o f s t r i n g
to pre ve nt th e drai n hos e fr om
moving.
B. In a standpipe
The standpipe must be no shorter
than 32 in. (81cm) and no longer
than 39 in. (100cm).
C. In a laundry tub.
The laundry tub must be no shorter
than 32 in. (81cm) and no higher
than 39 in. (100cm).
Step 4: Connect the drain hose
Standpipe
Hose
Retainer
Tie
strap
39 in. Max
32 in. Min
Laundry tub
Hose
Retainer
Tie
strap
39 in. Max
32 in. Min
Make sure that the connection between the drain hose and the wash basin,
standpipe or laundry tub is not airtight.
Run a test cycle as follows to check if your washer is properly installed.
WARNING
Pulsator
WARNING
WARNING
15
16
Bekijk gratis de handleiding van Midea MLTW09M1BWW, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Midea |
| Model | MLTW09M1BWW |
| Categorie | Wasmachine |
| Taal | Nederlands |
| Grootte | 6244 MB |
