Handleiding
Je bekijkt pagina 37 van 48
12
2. Adjustment of minimum level of the flame.
1. Turn the taps down to minimum.
2. Remove the knob from the tap and place a small
bladed screwdriver in the centre of the Adjustment
screw.
3. The correct adjustment is obtained when the flame has
a length of about 3-4 mm.
- For butane/ propane gas, the adjusting screw must.
- be tightly screwed in.
- Refit the control knob.
4. Repeat this process for each one of the gas taps.
Control handle
Tap
Sealing ring
Make sure that the flame does not go out by quickly
turning from maximum flow to minimum flow. If it
does then remove the control knob and make further
adjustments to the gas flow, testing it again once the
adjustment has been made.
Do not dismantle the tap shafe: in the event of a malfunction, change the whole tap.
Before placing the burners back on the top place, make sure that the injector is not
blocked.
A full operational test and a test for possible leakages must be carried out after gas
conversion, (such as soap water or gas detector)
After completing conversion, a qualified technician or installer has to mark “V” on
the right gas category to match with the setting in rating plate. Remove the previ-
ous setting “V” mark.
Caution
Adjustment
screw
Bekijk gratis de handleiding van Midea MH 604 FX G, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Midea |
| Model | MH 604 FX G |
| Categorie | Fornuis |
| Taal | Nederlands |
| Grootte | 3241 MB |
