Midea MDWEF1034DSS-WE handleiding
Handleiding
Je bekijkt pagina 86 van 147
• When removing or installing the lower
spray arm, first flatten the spray arm
as shown.
• Hold the spray arm while holding the
bottom nut at the same time to prevent
the spray arm from rotating.
• When installing the lower spray arm,
press the spray arm down to make it
fasten after alignment.
• Do not disassemble the spray arm after
unloading it. It is difficult to reassemble
after disassembling.
NOTE
36
5. Reassemble the filters in the reverse
order of the disassembly, replace the
filter insert, and rotate clockwise to
the close arrow.
Install the lower spray arm back.
It is necessary to clean the spray arms regularly for hard water chemicals will clog the
spray arm jets and bearings.
To clean the spray arms, follow the instructions below:
Spray arms
Do not over tighten the filters. Put the filters back in sequence securely, otherwise
coarse debris could get into the system and cause a blockage.
Never use the dishwasher without filters in place. Improper replacement of the filter
may reduce the performance level of the appliance and damage dishes and utensils.
1. To remove the upper spray arm, hold
the nut, rotate the arm clockwise to
remove it.
2. To remove the lower spray arm, pull
out the spray arm upward.
3. Wash the arms in soapy and warm
water and use a soft brush to clean
the jets. Replace them after rinsing
them thoroughly.
WARNING
EN
Bekijk gratis de handleiding van Midea MDWEF1034DSS-WE, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Midea |
| Model | MDWEF1034DSS-WE |
| Categorie | Vaatwasser |
| Taal | Nederlands |
| Grootte | 12150 MB |
