Handleiding
Je bekijkt pagina 22 van 424
18
EN
TROUBLESHOOTING
The following simple issues can be handled by the user. Please call the after-sale
service department if the issues are not solved.
Problem Possible Causes Solution
Not operate
The power supply is not turned on and the plug
is not firmly inserted.
Low voltage, power failure or part of the circuit
tripped.
Insert the power cord plug firmly.
Check the power supply at home.
Light not on
The appliance is not powered on.
The light is broken.
Unplug and re-plug the power cord.
Replace the light with a new one.
Fruits or
vegetables are
frozen
Has the food been placed at the back of the
fridge? The area near the back wall is where the
temperatures are coldest.
Fruits or vegetables are stored in the Fresh/
Chill zone.
Not placing food which may freeze
easily at the back of the fridge
compartment.
The Fresh/Chill zone is only for meat/
fish.
Fridge/freezer is
over-cooling
Temperature control is not set correctly. Set the temperature higher.
Compressor
working for a
long time
High ambient temperature causing long
working time.
Putting too much food in at one time.
Food is put in before it has cooled down.
Opening the door too often.
The frost layer inside is too thick.
This is normal.
Do not put too much food in at one
time.
Wait until the food has cooled down
before putting it in.
Do not open the door too often.
Need to defrost.
Door does not
close properly
Door is stuck with objects.
Too much food in.
Door gasket deformed.
Do not put in too much food.
Place the appliance stably.
Heat the door gasket, then cool it for
restoration (with an electrical drier or
hot water for heating).
Outer wall is hot
When the appliance is operating, heat is
dissipated to the outside through the metal
tubes inside the cabinet.
Higher ambient temperatures in the summer
cause the temperature of the outer wall to rise.
Higher temperature on the outer wall is
normal.
Increase the heat dissipation space, or
put the appliance in a ventilated and
cool place.
Cross or vertical
beams are hot
There are metal tubes inside the beams, and
the heat released from the tubes prevents
condensation.
This is normal.
Odors
Spoiled food
Food with strong odors
The interior compartment is dirty.
Clean and remove any spoiled food.
Make sure strong smelling food is
wrapped airtight.
Clean the interior compartment.
The actual
temperature
differs from the
set temperature
When warm food is put in, the temperature will
rise temporarily.
After setting a new temperature, it will
take some time for the temperature in the
compartment to reach the set temperature
when the door is not opened.
After the temperature stability, the actual
temperatures at different locations within the
compartment are different, with a deviation of
about ±3°C.
This is normal.
Wait for some time before testing the
actual temperature.
Condensation
forms on the
outside
Condensation may form when the humidity in
the room is high.
This is normal. Wipe off the
condensation using a dry cloth.
Bekijk gratis de handleiding van Midea MDRB593FGE46, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Midea |
| Model | MDRB593FGE46 |
| Categorie | Koelkast |
| Taal | Nederlands |
| Grootte | 33884 MB |
