Microchip MPFS460TL handleiding
Handleiding
Je bekijkt pagina 50 van 61
FlashPro Express User Guide
49
Electrical Specifications
FlashPro6
The FlashPro6 is a JTAG-based programmer for flash based Microsemi devices.
The FlashPro6 output is supplied via a connector to which a detachable 10-pin cable is fitted. The connector on
the FlashPro6 unit is a 2x5, RA male Header connector, which is manufactured by 3M and has a manufacturer’s
part number of N2510-5002-RB. This is a standard 2x5, 0.1 pitch connector which is keyed. Use the 10 pin right-
angle header, 3M P/N N2510-5002-RB (DigiKey P/N MHE10K-ND) for FlashPro6 and use the 10 pin straight
header,
The signals on the pins of the FlashPro6 10-pin connector are shown in the figure below.
Figure 25 · FlashPro6 10-Pin Connector
Note: All ground pins must be connected. The rectangular shape shows connections on the programmer itself.
Arrows show current flow towards or from the rectangular programmer.
The table below shows a description of the signals.
Table 4 · FlashPro6 Signal Description
Signal Description
GND Signal reference
TCK/SCK JTAG clock; SPI clock
TDI/SDI JTAG data input to device; SPI MOSI
TDO/SDO JTAG data output from device; SPI MISO
TMS/SS# JTAG mode select; SPI Chip Select
nTRST Programmable output pin may be set to off, toggle, low, or high level
VJTAG Reference voltage from the target board
Bekijk gratis de handleiding van Microchip MPFS460TL, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Microchip |
| Model | MPFS460TL |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 10235 MB |
