Microchip MPFS095TL handleiding
Handleiding
Je bekijkt pagina 19 van 61
FlashPro Express User Guide
18
FlashPro5/4/3/3X Programmer Settings
For FlashPro5/4/3/3X, if you choose the Force TCK Frequency, select the appropriate MHz frequency. For
FlashPro4/3X settings, you can switch the TCK mode between Free running clock and Discrete clocking. Discrete
clocking should be used when there is a JTAG non-compliant device in a chain with Microsemi devices. After you
have made your selections(s), click OK.
Default Settings
• The Force TCK Frequency option is unchecked to instruct the FlashPro5/4/3/3X to use the TCK frequency
specified by the Frequency statement in the PDB/STAPL file(s).
• FlashPro5/4/3/3X default TCK mode setting is Free running clock.
TCK Setting (Force TCK Frequency)
If Force TCK Frequency is checked (in the Programmer Setting), the selected TCK value is set for the
programmer and the Frequency statement in the PDB/STAPL file is ignored.
Default TCK frequency
When the IPD/STAPL file or Chain does not exist, the default TCK frequency is set to 4MHz. When more than
one Microsemi flash device is targeted in the chain, the FlashPro Express software passes through all of the files
and searches for the "freq" keyword and the "MAX_FREQ" Note field. The FlashPro Express software uses the
lesser value of all the TCK frequency settings and the "MAX_FREQ" Note field values.
Ping Programmers
Right-click a programmer and choose Ping.
Note: You can click the Refresh/Rescan for Programmers button to quickly ping new programmers.
Performing a Self-Test
Right-click the programmer you want to self-test and choose Self Test.
Note: You must connect the programmer to the self-test board that comes with your programmer before
performing a self-test.
Note: Self-test is not supported with FlashPro5/4 programmers. These programmers are rigorously tested
at the factory during production.
Scanning and Checking a Chain
The scan chain operation scans and analyzes the JTAG chain connected to programmer(s) you have selected
and checks that chain scanned matches the chain configured in FlashPro Express.
To scan a chain:
Right-click the programmer you want to scan and choose Scan and check chain.
Enabling and Disabling Programmers
After loading a job project, you can enable/disable or remove a programmer and can also ping, self-test, run scan
and check chain on any of the connected programmers. These actions are available in the shortcut menu (right-
click) for each of the programmers listed in the programmer column.
Click the checkbox next to a programmer in the Programmer column to enable or disable it. The programmer is
enabled when there is a tick mark in the checkbox and disabled when the checkbox is empty.
Renaming a Programmer
Enter the new programmer name in the Programmer window to rename the programmer. By default, the
programmer name is the same as the programmer ID.
Bekijk gratis de handleiding van Microchip MPFS095TL, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Microchip |
| Model | MPFS095TL |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 10235 MB |
