Microchip MPF500TS handleiding
Handleiding
Je bekijkt pagina 32 van 36
Appendix: Programming PolarFire FPGA Using the On-Board FlashPro5
Microchip UG0786 Revision 5 26
8 Appendix: Programming PolarFire FPGA
Using the On-Board FlashPro5
The PolarFire Splash Board includes an on-board FlashPro5 programmer. An external programmer
hardware is, therefore, not required to program the PolarFire device. The device can be programmed
using the FlashPro software installed on the host PC.
Follow these steps to program an on-board PolarFire device using the on-board FlashPro5 programmer:
1. Connect the power supply cable to the J2 connector on the board.
2. Connect the USB cable from the host PC to the J1 connector (FTDI port) on the board.
3. Power on the board using the SW1 slide switch.
When the board is successfully set up, the LEDs start glowing.
4. On the host PC, start the FlashPro software.
5. Click New Project to create a new project.
6. In the New Project window, do the following, and click OK:
• Enter a project name.
•Select Single device as the programming mode.
7. Click Configure Device.
8. Click Browse, and select the .stp file from the Load Programming File window.
Note: The programming file will be available in a future release.
9. From the View Programmer pane, select the on-board FlashPro5 programmer, as shown in the
following figure.
Figure 19 • Selecting the On-Board FlashPro5
10. Click Program to program the device.
The Programmer List window in the FlashPro software shows the programmer name, programmer
type, port, programmer status, and information about whether the programmer is enabled.
11. When the device is programmed successfully, a Run Program PASSED status is displayed.
Bekijk gratis de handleiding van Microchip MPF500TS, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Microchip |
| Model | MPF500TS |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 5215 MB |
