Metra 99-8163 handleiding
Handleiding
Je bekijkt pagina 9 van 16
REV. 2/4/2021 INST99-8163
9
1. Secure the completed assembly into the dash using the factory hardware.
2. Reassemble the dash in reverse order of disassembly to complete the installation.
FINAL ASSEMBLYPROGRAMMING
Attention! If the interface loses power for any reason, the following steps will need to be
performed again.
1. Refer to step 2 from the “Installation” section.
2. Start the vehicle.
3. Program the kit:
a. Once the touchscreen display loads up, select the vehicle type; “Lexus IS”.
b. Wait until the radio comes on, and the touchscreen display shows “SWC Configured*”.
This process may take up to 3 minutes.
Note: If the touchscreen display does not load up, or the radio doesn’t come on within 3
minutes, and/or the touchscreen display does not show “SWC Configured*”, turn the vehicle
off and disconnect the 8163 harnesses from port “A” in the touchscreen display. Check all the
connections, reconnect the harness into the touchscreen display, and then try again.
4. Cycle the key off, then back on. If the driver’s door is closed, open and close the door.
5. Test all functions of the installation for proper operation, before reassembling the dash.
Bekijk gratis de handleiding van Metra 99-8163, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Metra |
| Model | 99-8163 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 1737 MB |
