Metra 99-6527B handleiding
Handleiding
Je bekijkt pagina 10 van 16
386.257.1187
|
MetraOnline.com
1010
I N STALL ATI O N PROGRAMMING
Attention! It is highly advisable to read the following steps beforehand, to ensure a clear
understanding of what is to be expected. The following steps must be done in the order that they
are numbered.
With the vehicle completely off:
1. Connect the 16-pin harness with stripped leads
into port “B” in the touchscreen display.
2. Connect the 6527 harness to the wiring harnesses in the vehicle. These harnesses are the
ones removed in step 7 of dash disassembly. Then insert the
6527 harness into port “A” in
the touchscreen display. But do not install this harness until exactly before step 1 from the
Programming section. This is a timed process.
3. Connect the 4-pin harness with yellow RCA jacks into port “C” in the touchscreen display.
4. Connect the hazard harness’s (LD-CHRYHAZ2)
10-pin connector
into port “D” in the
touchscreen display, and then to the vehicle’s
8-pin hazard connector
in the vehicle.
5. Disregard port “E”, it will not be used in this application.
6. Port “F” is an update port for future firmware upgrades.
7. Locate the factory antenna connector in the dash and complete all necessary connections to
the radio. Metra recommends using the proper mating adapter available from Metra.
A
B
C
E
F
D
1. Refer to step 2 from the Installation section.
2. Press the push-to-start button to start the vehicle.
3. Program the kit:
a. Once the touchscreen display loads up, select the vehicle type.
b. Wait until the radio comes on, and the touchscreen display shows SWC Configured*.
This process may take up to 3 minutes.
Note: If the touchscreen display does not load up, or the radio doesn’t come on within
3 minutes, and/or the touchscreen display does not show SWC Configured*, check all
connections, then reset the interface and try again. Refer to the Troubleshooting section.
4.
Cycle the key off. If the driver’s door is closed, open and close the door. Cycle the key back on.
5. Test all functions of the installation for proper operation, before reassembling the dash.
Note: Refer to the Troubleshooting section for factory items known to be no longer functional
.
1. Secure the completed assembly into the upper dash using the factory screws.
2. Reassemble the center console and dash in reverse order of disassembly.
FINAL ASSEMBLY
Note: DO NOT CONNECT
Bekijk gratis de handleiding van Metra 99-6527B, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Metra |
| Model | 99-6527B |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 1877 MB |
