Metra 99-5834CH handleiding
Handleiding
Je bekijkt pagina 10 van 32
386.257.1187
|
MetraOnline.com
10
It is highly advisable to read the following steps beforehand, to ensure a clear understanding of
what is to be expected. The following steps must be done in the order that they are numbered.
With the vehicle completely off:
Touchscreen display
1.
Connect the two pin plug to the mating two pin plug on the camera harness (LD-FD54CAM)
2. Connect the 5834 harness to the wiring harnesses in the vehicle. These harnesses are
the ones removed in step 7 of dash disassembly. Then insert the 5834 harness into port
“A” in the touchscreen display. But do not install this harness until exactly before step 1
from the Programming section. This is a timed process..
3.
Connect the 4-pin harness with yellow RCA jacks into port “C” in the touchscreen display
.
4. Disregard ports “D” and “E”, they will not be used in this application.
5. Port “F” is an update port for future firmware upgrades.
A
B
C
E
F
D
HVAC interface
6. Connect the HVAC interface harness into the HVAC interface, and then to the
wiring harnesses in the vehicle. These harnesses are the ones removed in step 4
of dash disassembly.
Attention! Disregard the 10-pin connector from the HVAC interface harness, it will not be
used in this application.
7. Connect the 4-pin flat to 4-pin stacked harness into the HVAC interface, and then to the
passenger airbag light assembly.
8. Connect the 6-pin harness from the 5834 harness to the HVAC interface.
9. (a) For models with a 4.2-inch display screen: Connect the 12-pin backup camera
harness to the wiring harness in the vehicle. This harness is the one removed in step 5
of dash disassembly.
(b) For models with an 8-inch display screen: Connect the female connector from
the 54-pin backup camera harness
to the wiring harness in the vehicle. This connector is
located behind the factory display screen, which was removed in step 5 of dash disassembly.
Note: Disregard the male connector, it will not be used in this application.
10. Locate the factory antenna connector in the dash and complete all necessary
connections to the radio. Use the antenna adapter provided to adapt the factory
antenna connector to the aftermarket radio.
INSTALLATION
Note: DO NOT CONNECT!
Bekijk gratis de handleiding van Metra 99-5834CH, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Metra |
| Model | 99-5834CH |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 4269 MB |
