Handleiding
Je bekijkt pagina 11 van 60
EN - 11
QUICK GUIDE
INITIAL UNIT CONFIGURATION
Caution: Before starting up the unit for the first time, ensure that the main power connection cable
and the battery charge test cable are connected properly.
The unit will initially show its software version on the display when powered up for the first time.
After a few seconds, it will enter initial configuration mode in order to select maximum unit power
between 1.2 (1230 W) or 2.0 (2020 W) from the control panel. Select the required option with the up or
down buttons on the panel or remote control and confirm by pressing the ON/OFF button on the unit.
Warning: The unit’s maximum power must be selected based on the vehicle’s size and thermal
requirements, as well as the type of batteries installed in the vehicle, in order to ensure the unit’s
operating autonomy.
After confirming the power, the user can select battery type and the unit it is connected to, selecting
between lead acid (Pb) or lithium (Li) battery. Select the required option using the up or down buttons
on the control panel or remote control and confirm with the ON/OFF button on the unit.
The user must select the measurement scale, either degrees Celsius (ºC) or degrees Fahrenheit (ºF),
in order to complete the configuration. Select the required option using the up or down buttons on
the control panel or remote control and confirm with the ON/OFF button on the unit. After this last
confirmation, the unit will go off and remain ready to power up.
If you wish to reset the unit’s power, simply press the MODE and CLOCK buttons on the control panel at
the same time with the unit turned off to return to the settings. This must be reset by fully disconnecting
it from the power source in order to change the battery type or temperature measurement scale.
CONTROL PANEL OPERATION
4 53
21
9 10 12 13
76
8 11
1. ON/OFF: Unit On/Off button. Pressing once turns the unit on and leaves it ready for operation.
Pressing again turns the unit off.
Pressing and holding the On/Off button turns the LED on at maximum brightness; holding it down
gradually decreases brightness by approximately 20% every half second; and releasing the button
will maintain the same brightness as the LED.
2. MODE: Select the unit’s operating mode from between AUTO, ECO and VENTILATION.
Bekijk gratis de handleiding van Mestic RTA-2000, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Mestic |
| Model | RTA-2000 |
| Categorie | Airco |
| Taal | Nederlands |
| Grootte | 2612 MB |