Meridian 218 handleiding
Handleiding
Je bekijkt pagina 27 van 32
Meridian 218 Zone Controller User Guide
22
Comms
System Address: If an installation contains multiple zones
that are connected together with Meridian Comms, each
one needs a different System Address if they are to have
independent source selection and volume controls. If the
installation uses LAN connections then this can be left at its
default, 1A.
Product Address: If there are two or more Meridian sources
in the same category on the same Comms-connected system
then each unit must have a different Product Address. The
setting does not apply to IP connected systems and should be
left at its default, 1A.
IR mode: The IR mode is only relevant if a G12 has been
connected to the 218. In this setup the installer should set the
mode to Controller to ensure that the unit functions as the
system controller.
IR receiver is currently: Shows the state of the IR receiver.
Ethernet
Allows you to change the Ethernet configuration. Note that
incorrect settings may make the 218 unreachable via the web
page.
Bekijk gratis de handleiding van Meridian 218, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Meridian |
| Model | 218 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 3464 MB |
