Mennekes Ladekabel Mode 2 3.7kW handleiding

Niet gecategoriseerd

Mennekes

94 pagina's

PDF beschikbaar

Handleiding

Start charging process

The charging process can be started as soon as the charging

cable is connected to the infrastructure. Please also note the

documentation for your electric vehicle.

The self-test function of the device when switching on

checks all important parameters and only enables the

charge, if all test criteria are fulfilled.

In the case of temporary power failure, the charging pro-

cess will be automatically continued after the voltage is

restored.

Terminate charging process

Do not remove the plug, while the charging process is still

active.

f Terminate the charging process at your vehicle first.

Please note the documentation for your electric vehicle.

After use, re-attach the factory-mounted protective cap.

Wind the charging cable without kinks and store it properly

in your vehicle.

Please note cover page – image 2 and 5.

Please note cover page – image 3.

Note for plug / coupling type GB and type 1:

Press the release button of the charging

connector for unplugging.

Please note cover page – image 4.

Status of the light‑emitting diodes

LED 1 LED 2 State

flashes blue flashes blue

self-test

flashes orange flashes orange

flashes red flashes red

lights up

blue

off No vehicle connected.

flashes

blue

off Vehicle connected.

flashes

blue

flashes

blue

Charging process active.

off flashes

orange

Temperature too high.

Charging will be continued with

reduced charging current.

off lights up

orange

Temperature critical.

Charging will be stopped.

off flashes

red

Fault current occurred.

flashes

red

lights up

red

Fault current in domestic installation –

PE missing.

flashes

red

flashes

red

Critical error –

Device is damaged and must be

repaired by the manufacturer.

lights up

red

lights up

red

Internal fault –

Temperature sensor defective

FI test negative

Reset fault massages:

f Disconnect the charging cable from the power supply by

removing the plug from the wall socket.

f Reinsert the device after 10 seconds.

Errors due to temperature excess:

f Before the charging process, store the device at a place

with suited ambient temperature.

Please note the data plate on the housing.

Faults which show a damage to the charging cable

are not reset.

These include:

 Critical fault

 Internal fault – temperature sensor defective

 Internal fault – FI test negative

If the device shows damages, it must be checked by an

expert and be replaced, if necessary. In the case of repair,

please contact the specialist dealer / manufacturer.

STI_BAL_LK-Mode2_v09_xx-xx-2016_de_(Europa).indd 24 2017-04-20 12:33:38

Bekijk gratis de handleiding van Mennekes Ladekabel Mode 2 3.7kW, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.