Meireles MG 4755 X handleiding
Handleiding
Je bekijkt pagina 23 van 164
23
Flame Output Speed Setting
After replacing the injectors, it is also necessary to adjust the gas
taps to the new type of gas.
Before starting the operation, make sure that the appliance plug is
plugged in, the gas supply is on and the burners are completely placed.
Note: Gas setting screw for the low ame position must be loos-
ened when switching from LPG to natural gas. During switching from
natural gas to LPG, it should be tightened.
1. Put the hob burners in a low position and pull out the hob control
knobs on the control panel (see gure 4).
2. Tighten/loosen the gas setting screw shown in gure 5 with the
help of a screwdriver of the proper size (see gure 6). This enables the
ame in the low position to increase or decrease. Adjust the proper
gas setting so that the ame length is at least 4 mm.
3. For the nal check, turn the ames of the hob burners to the highest
and lowest positions. In both cases, the ame must be ignited.
4. Repeat these procedures for each burner of the hob.
5. After making the proper gas setting, install the control knobs in
order to use the product.
WARNING: Depending on the type of hob spout
used in your product, the position of the gas setting
screw may vary.
Figure 4
Figure 6Figure 5
Bekijk gratis de handleiding van Meireles MG 4755 X, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Meireles |
| Model | MG 4755 X |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 13075 MB |