Megger EVX100 handleiding
Handleiding
Je bekijkt pagina 6 van 24
www.megger.com
EVX100
6
Safety Warnings and Standards
2. Safety Warnings and Standards
These safety warnings must be read and understood before the instrument is used.
Retain for future reference.
EVSE: Electric Vehicle Supply (Charging) Equipment
2.1 Warnings, Cautions and Notes
This user guide follows the internationally recognised definition. These instructions must be
adhered to at all times.
Description
WARNING : Indicates a potentially dangerous situation which, if ignored, could lead to
death, serious injury or health problems.
CAUTION : Indicates a situation which could lead to damage of the equipment or
environment
NOTE : Indicates important instructions to be followed to perform the relevant process safely and
efficiently.
2.2 Safety warnings
The equipment must be used only by suitably trained and competent persons.
National Health and Safety Legislation requires users of this equipment or their employer
to carry out valid risk assessment of all work so as to identify potential sources of danger
and to mitigate risk.
If this equipment is modified or used in a manner other than specified by the
manufacturer, the protection provided by the equipment may be impaired.
This equipment is not intrinsically safe and must not be used in hazardous atmospheres.
This equipment is for indoor and outdoor use up to 2000 m altitude. It must not be used
in wet conditions or outside the specified temperature range.
If the equipment gets wet, disconnect and do not use. Clean equipment with a dry, clean
cloth.
Inspect the equipment for damage before each use. The equipment must not be used if
any part of it is damaged.
Voltage measurements must not be relied on, and independent means used to verify
whether circuits are energised. If no voltage is measured, this may be because an EVX’s
internal fuse has blown.
Do not use the EVX if the MFT fails to detect it.
Continuity of protective conductors and earthed equipotential bonding of new or
modified installations must be verified before powering up the EVSE to be tested.
Plug in the EVX to the MFT before connecting to the EVSE to be tested. Similarly,
disconnect from the EVSE before unplugging the EVX and MFT.
Do not connect USB cable when EVX is connected to EVSE.
Use only Megger approved adapters with this product.
Bekijk gratis de handleiding van Megger EVX100, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Megger |
| Model | EVX100 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 3687 MB |