MDT SCN-BWM55.02 handleiding
Handleiding
Je bekijkt pagina 7 van 67
MDT technologies GmbH · Papiermühle 1 · 51766 Engelskirchen · Germany
Telephone: +49 (0) 2263 880 · knx@mdt.de · www.mdt-group.com
7 / 67
Technical Manual
Motion Detector/Automatic Switch 55/63 [SCN-BWM55/63(T)(06).x2]
State 07/2025 - Version 1.4
2.4 Structure and handling
The following picture shows the structure of the device:
Figure 2: Structure and handling
1 – KNX Bus connection terminal 2 – Programming button
3 – State and Programming LED (red) 4 – State LED (green)
5 – Brightness sensor 6 – Sensor buttons
7 – White LED S1 / S2 – Motion sensors
2.5 Commissioning
1. Wire the device according to the wiring diagram.
2. Connect programming interface to the bus.
3. Switch on bus voltage.
4. Press the programming button on the bottom left of the device
(red programming LED lights up continuously).
5. Set and programme the individual address in the ETS (programming LED turns off).
6. Congureandprogrammethesettingsintheapplicationprogramme.
Back: SCN-BWM55/63(T).x2
11
Structure: SCN-BWM55/63.x2
↑↑
22
3344
55
44
77 77
S1S1 S2S2
Structure: SCN-BWM55/63T.x2
↑↑
22
3344
55
66
66
44
77 77
S1S1 S2S2
Bekijk gratis de handleiding van MDT SCN-BWM55.02, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | MDT |
| Model | SCN-BWM55.02 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 10289 MB |
