McGregor GCS4002 handleiding
Handleiding
Je bekijkt pagina 17 van 32
After Sales Support 0345 605 2065
V1.7 03/23
Safety information
Important - Please read these instructions fully before use
Instructions concerning the proper techniques for basic felling,
limbing, and cross-cutting
When the log is supported on one end, as illustrated in Figure 4, cut
1/3 the diameter from the underside ( underbuck) (1). Then make
the nished cut by overbucking (2) to meet the rst cut.
When the log is supported on both ends, as illustrated in Figure 5,
cut 1/3 the diameter from the top (overbuck) (1). Then make the
nished cut by underbucking (2) the lower 2/3 to meet the rst cut.
2
2/3
1
1/3
Figure 5 Figure 6
When bucking on a slope always stand on the uphill side of the
log, as illustrated in Figure 6. When “cutting through”, to maintain
complete control release the cutting pressure near the end of the
cut without relaxing your grip on the chain saw handles. Don’t let the
chain contact the ground. After completing the cut, wait for the saw
chain to stop before you move the chain saw. Always stop the motor
before moving from tree to tree.
17 of 31
Bekijk gratis de handleiding van McGregor GCS4002, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | McGregor |
| Model | GCS4002 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 3478 MB |
