McGregor GCS4002 handleiding
Handleiding
Je bekijkt pagina 15 van 32
After Sales Support 0345 605 2065
V1.7 03/23
Safety information
Important - Please read these instructions fully before use
Instructions concerning the proper techniques for basic felling,
limbing, and cross-cutting
3. Felling back cut
Make the felling back cut (Y) at least 50 mm higher than the
horizontal notching cut as illustrated in Figure 1. Keep the felling
back cut parallel to the horizontal notching cut. Make the felling
back cut so enough wood is left to act as a hinge. The hinge wood
keeps the tree from twisting and falling in the wrong direction. Do
not cut through the hinge.
As the felling gets close to the hinge, the tree should begin to fall.
If there is any chance that the tree may not fall in desired direction
or it may rock back and bind the saw chain, stop cutting before the
felling back cut is complete and use wedges of wood, plastic or
aluminium (Z) to open the cut and drop the tree along the desired
line of fall (
3
).
When the tree begins to fall remove the chain saw from the cut,
stop the motor, put the chain saw down, then use the retreat path
planned (
2
). Be alert for overhead limbs falling and watch your
footing.
2 2
3
W
Y
Z
X
50 mm
50 mm
1
1
1
Figure 1
15 of 31
Bekijk gratis de handleiding van McGregor GCS4002, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | McGregor |
| Model | GCS4002 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 3478 MB |
