MBM LTD832S handleiding
Handleiding
Je bekijkt pagina 22 van 40
DISHWASHER INSTRUCTIONS MANUAL
Page 14 of 28 MDIISY31-(r05)
UK
5.6 Installation of dispensers
The machine is equipped with specific outputs for rinse aid and detergent dosing devices. Connect the
dosing devices as shown in the wiring diagram to ensure the correct operation of the machine.
The rinse aid and detergent must be dosed by the automatic dispensers.
The amount of both of these products is established by the installation technician based on local water
hardness, and the technician also calibrates the dispensers themselves.
For the initial filling of the dosing circuit and the relative settings, see the "Settings” paragraph.
The level of liquids in the containers must never be allowed to reach empty.
The dispensers must never be filled with corrosive or contaminated products.
Chlorine-based products must not be used under any circumstances, as they cause the formation of
chloride, which in concentrations above 50 ppm can lead to corrosion
It is not advisable to dispense the products manually.
For any other installation, refer to the wiring and installation diagrams enclosed
The machine cannot be fitted with multi-voltage dosing devices and/or dosing devices with
absorption higher than 5A per output.
If you wish to use this type of dosing device, it must be connected to an external 16A relay
WARNING!
The use of detergents containing chlorides in a concentration exceeding 50 ppm can lead to
corrosion of the machine's stainless steel structure.
5.7 Installation of protection curtains
The machine is equipped with protection curtains to separate the various sections of the machine.
For the assembly diagram, see figure 12.
5.8 COMMISSIONING
5.8.1 First boiler filling
The boiler is empty at the time of initial machine installation, so the electrical elements are disconnected
in order to prevent idle operation which could result in damage.
To activate the elements, follow the first boiler charging procedure as described below.
5.8.2 Machine equipped with single boiler
Reference: Figures 2 and 6
Open the gate valve of the water supply system (Fig. 2/A)
Supply the machine with power by switching on the main switch (Fig. 2/B)
The display will show 4 horizontal bars (Fig. 2/C)
Press the line button (1) to switch the machine on. (Fig. 2/D)
The display will show the alternating message “FI?” “no” (Fig. 6/A)
Press button (3) to select “yES” (Fig. 6/A)
To confirm, press button (2). (Fig. 6/C)
The machine will automatically start loading the boiler, and the display will show the message “FI”
(Fig. 6/D)
When the display shows the alternating messages “LoAd” “End”, it means the loading phase is
concluded, and the machine is ready to be switched on. (Fig. 6/E)
Bekijk gratis de handleiding van MBM LTD832S, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | MBM |
| Model | LTD832S |
| Categorie | Wasmachine |
| Taal | Nederlands |
| Grootte | 5903 MB |
