MBM LTD822S handleiding
Handleiding
Je bekijkt pagina 62 van 150
DISHWASHER INSTRUCTIONS MANUAL
Page 8 of 21 MDIISY31-(r01)
UK
Installation of dispensers
4.5
The machine is equipped with specific outlets for the dispensers for rinse aid and dish washing liquid.
Connect the dispensers according to the wiring diagram, to ensure that the machine works properly.
Both the rinse aid and the washing liquid must be dosed by the automatic dispensers.
The amount of both products is established by the installation technician, according to water hardness.
The technician
is responsible for calibrating the dispensers.
For the initial filling of the dosing circuit and for its relative regulations, please refer to the "Regulations"
paragraph.
• The level of liquids in the containers must never be allowed to drop to empty levels.
• The dispensers must never be filled with corrosive or soiled products.
• It is forbidden to use chlorine-based products, as they cause the formation of chlorine; in
concentrations above 50 ppm, they may lead to corrosion.
• It is not advisable to dispense the products manually.
• For any other installation, please refer to the wiring and installation diagrams attached.
• The machine does not support multi-voltage dispensers and/or with more than 5 A of absorption per
outlet.
If you decide to use this kind of dispenser, it must be connected to an external 16 A relay.
COMMISSIONING
4.6
4.6.1 First boiler charging
Reference: Figures 2 and 6
• Open the gate valve of the water supply system (Fig. 2/A)
• Supply the machine with power by switching on the main switch (Fig. 2/B)
• The display will show 4 horizontal bars (Fig. 2/C)
• Press the line button (1) to switch the machine on. (Fig. 2/D)
• The display will show the alternating message “FI?” “no” (Fig. 6/A)
• Press button (3) to select “yES” (Fig. 6/A)
• To confirm, press button (2). (Fig. 6/C)
• The machine will automatically start loading the boiler, and the display will show the message “FI”
(Fig. 6/D)
• When the display shows the alternating messages “LoAd” “End”, it means the loading phase is
concluded, and the machine is ready to be switched on. (Fig. 6/E)
Controls
4.7
• Make sure that the level of water in the washing tank, once filled, is 1-2 cm below the overflow
level.
• Make sure that the temperature of the washing and rinsing tank is in accordance with the
settings.
• Check the dispensers for proper function.
• Make sure the rinsing economiser is working well: it must start dispensing hot water as soon as
a basket arrives beneath the rinsing jets, and make the hot water flow stop when the basket
moves away.
• Make sure the limit switch is working. The switch must block the functioning of the advancement
motor and of the pump whenever a basket reaches the end of the plane. Once the basket is
removed, the functioning must resume.
• Check the rotation direction of the pumps. If they are turning in the opposite direction, invert the
two phases of the power supply cable.
Bekijk gratis de handleiding van MBM LTD822S, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | MBM |
| Model | LTD822S |
| Categorie | Wasmachine |
| Taal | Nederlands |
| Grootte | 21127 MB |
