MBM LS527CPDA handleiding
Handleiding
Je bekijkt pagina 13 van 194
INSTRUCTION MANUAL FOR DISHWASHERS
Page 11 of 16
UK
4.9 Removing the integral filter
Move the washing and rinsing arms at right angles to the edge of the door
Lift each semi-filter by the relative handle ( Fig.7 ).
4.10 Emptying the dishwasher
4.10.1 Appliances with no drain pump
Switch the dishwasher off.
Remove the integral filter ( Fig.7A ).
Pull up and remove the overflow pipe ( Fig.7 ).
Wait for the tub to empty completely.
If necessary, extract the tub filter and clean.
4.10.2 Appliances with drain cycle (*optional)
With the machine on, press the PROGRAMME SELECTION button (3) to select the programme
ProClean or ProDrain.
Press the START button (4), to start the drain and self-clean programme.
At the end of the drain cycle, the dishwasher will switch off; only the STANDBY LED (5) will remain
illuminated to indicate that the mains power is on.
4.11
Resin regeneration (*optional)
In machines with an incorporated water softener the “REGENERATION SYSTEM ON” symbol
indicates that the machine is running a resin regeneration cycle and that the current wash
programme could be longer.
N.B. Do not switch off the machine if a regeneration cycle is underway
In machines fitted with water softener, when the warning ‘NO SALT’ appears you should add salt to the
relative container; proceed as follows:
Remove the basket from the machine.
Remove the integral filter (
Fig. 7
).
Unscrew the cap on the salt container (
Fig. 8
).
Pour approx. 700g of regeneration salt (1or 2mm grain size kitchen salt with no additives) into
the container using the funnel supplied.
Close the container firmly.
After a few minutes the ‘NO SALT’ warning will disappear.
4.12 Machine with external water softener
On machines equipped with an external water softener, after a certain number of cycles, the word
‘SERVICE’ will appear on the display; this means that it is necessary to regenerate the resin of the
external water softener. The service alert will remain even when the machine is off. To cancel it, press
and hold all 4 buttons for at least 5 seconds, with the machine off and the door open.
4.13 End of shift
At the end of the day always drain the machine as described in the section Machine draining.
Disconnect the power supply by means of the main switch and close the external water cock.
Perform routine maintenance and clean the machine as described in the section Maintenance.
If possible, leave the door ajar to prevent bad odours building up inside the machine.
Bekijk gratis de handleiding van MBM LS527CPDA, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | MBM |
| Model | LS527CPDA |
| Categorie | Vaatwasser |
| Taal | Nederlands |
| Grootte | 23488 MB |
