MBM LK626PL handleiding
Handleiding
Je bekijkt pagina 11 van 155
INSTRUCTION MANUAL FOR DISHWASHERS
Page 9 of 14
UK
Rinse the area around the salt cap by hand and run a self-cleaning cycle to avoid any risk of
corrosion.
The ‘SLT’ warning will disappear after a few minutes.
The warning rEG on the display indicates that the machine is running a resin regeneration cycle,
needed to ensure the correct operation of the water softener; while this warning is shown, the cycles
run could be longer than usual.
N.B. Do not switch off the machine if a regeneration cycle is underway
4.11 Displaying information
With the dishwasher on, press PROGRAMME SELECTION (2) for five
seconds, in sequence the following are shown:
“t” wash temperature
“b” rinse temperature
“CC” wash cycles carried out during the life of the dishwasher.
4.12 List of viewable messages
Door open
Number of cycles carried out
Rinse temperature
End of cycle
Wash temperature
Automatic start enabled
Short wash
Continuous wash
Medium wash
Final drain
Long wash
Regeneration cycle or request
No salt in the softener
4.13 End of shift
At the end of the day always drain the machine as described in the section Machine draining.
Disconnect the power supply by means of the main switch and close the external water cock.
Perform routine maintenance and clean the machine as described in the section Maintenance.
If possible, leave the door ajar to prevent bad odours building up inside the machine.
Bekijk gratis de handleiding van MBM LK626PL, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | MBM |
| Model | LK626PL |
| Categorie | Vaatwasser |
| Taal | Nederlands |
| Grootte | 18586 MB |
