Maxview Roam Campervan MXL056 handleiding

Niet gecategoriseerd

Maxview

40 pagina's

PDF beschikbaar

Handleiding

Fitting the Antenna

These instructions are for the standard through-the-roof installation as supplied.

1. Once you have a suitable position for the antenna,

cut out the supplied template. Use to mark the 25mm

centre hole position and mark the outside of the

antenna.

2. At the marked centre position, drill a 2.5mm pilot

hole through the roof. Use a 25mm hole saw to drill

out the centre hole through the roof.

Tidy up the hole to remove swarf and sharp edges.

3. Use the Antenna clamp to gauge the depth of the

roof. The best way to do this is to sit the Antenna

clamp upside down through the hole. Then, from the

inside, mark on the clamp where the clamp passes

through the ceiling and into the vehicle.

3A. Please Note. Alternative Nut and Washer option

for thin metal roof applications is supplied. If this is

better suited for your application ignore step 3 & 4.

4. Remove the clamp and cut the clamp shaft to the

correct length. The correct length for your installation

will be the roof depth minus 3mm. This will ensure

the clamp does not bottom out on the antenna when

tightened.

E.g. If roof depth is 30mm. The clamp shaft should be

cut 27mm along the shaft.

B. Roof line

A. Cut line

A B

Front of vehicle

Bekijk gratis de handleiding van Maxview Roam Campervan MXL056, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.