Martin P3 PowerPort 500 IP Rental handleiding

Niet gecategoriseerd

Martin

28 pagina's

PDF beschikbaar

Handleiding

Martin

P3 PowerPort 2000 and 500 IP Safety, Installation and User Manual 11

P3 PowerPort 2000

Overview

Front panel

The front panel of the P3 PowerPort 2000 features status LEDs and a single button that runs test

sequences or reboots the device (see ‘Status LEDs and Test/Reset button’ on page 22).

Rear panel

The rear panel of the P3 PowerPort 2000 features the following:

• Hybrid (48 VDC power and data) outputs (7-pin DCE connectors)

• Network data in/thru ports A and B (Neutrik etherCON connectors)

• Switch that disables status LEDs and Test/Reset button

• Switch that manages the power level of the fixtures on the hybrid links

• AC mains power in (Neutrik PowerCon TRUE1 TOP connector)

Installing

Read the ‘Safety Information’ section starting on page 5 before installing, applying power to or operating

the device.

The P3 PowerPort 2000 is designed to be installed in a 19-inch rack, on a rigging truss or on a flat surface

in any orientation.

Rack mounting

To mount the P3 PowerPort 2000 in a 19-inch rack:

1. Fasten the two supplied short rack ears to the front of the device as shown in the illustration above

using the supplied screws. Do not fasten the supplied safety cable attachment bracket to the device.

2. Fasten the device into the rack. Bear in mind the need for good ventilation and the possible need for

fan cooling.

Hybrid outputs

Ethernet

IN/THRU

Switches

Mains

power IN

Status LEDs

Test/Reset

button

Bekijk gratis de handleiding van Martin P3 PowerPort 500 IP Rental, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.