Martin P3 PowerPort 500 IP Install handleiding

Niet gecategoriseerd

Martin

28 pagina's

PDF beschikbaar

Handleiding

12 Martin

P3 PowerPort 2000 and 500 IP Safety, Installation and User Manual

Truss mounting

When installing the P3 PowerPort 2000 on a rigging truss, use half-coupler type

rigging clamps (see Figure 1) that completely encircle the truss chord. Rigging

clamps must be in perfect condition and approved for the weight that they will

support.

To mount the device on a rigging truss, see Figure 2:

1. Using the four screws supplied for each ear, fasten the two supplied short rack

ears to the sides of the device at the edges of the top surface as shown in

Figure 2.

2. Using both the supplied screws, fasten the safety cable attachment bracket to

the back of the device as shown in Figure 2.

3. Using hardened steel fasteners with locking nuts, fasten two rigging clamps that are approved for the

weight that they will support to the two short rack ears.

4. Install the device on the truss by fastening the rigging

clamps onto the truss chord.

5. If there is any risk that the device may cause injury or

damage if it falls, secure it by fastening an approved

safety cable to the safety cable attachment bracket

and looping it around the truss or other secure

anchoring point. Remove as much slack as possible

from the safety cable by looping it more than once

around the truss chord, for example.

Surface mounting

To mount the P3 PowerPort 2000 on a secure, flat surface:

1. See illustration on right. Using the four

screws supplied for each ear, fasten

the two supplied short rack ears to the

device as shown. The safety cable

attachment bracket is not required.

2. Fasten the device to the surface using

suitable screws or bolts passed

through the short rack ears and

fastened into the mounting surface.

Connecting the device

Use the connectors that are specified for the P3 PowerPort 2000 to connect to AC mains power, network

data and the hybrid link. Connectors are labeled on the device and shown in ‘Rear panel’ on page 11.

Status LED and power mode settings

The two switches located on the rear panel let you manage the status LEDs and Test/Reset button on the

front panel, and manage the power setting of connected fixtures (see ‘Switches’ on page 10).

Operating

When power is applied to the power input cable, the device carries out a short boot procedure and then

becomes operational. There is no power on/off switch.

Status LEDs and Test/Reset button

You can monitor operation via the status LEDs on the front panel if they are activated using the switch on

the rear panel.

You can send test patterns to connected Martin Creative LED fixtures and reboot the device using the

Test/Reset button on the front of the device.

See ‘Status LEDs and Test/Reset button’ on page 22 for details of these two features.

Figure 1. Half-

coupler rigging

clamp

Figure 2. Truss mounting

Figure 3. Surface mounting

Bekijk gratis de handleiding van Martin P3 PowerPort 500 IP Install, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.