Martin Logan Dynamo 10 handleiding
Handleiding
Je bekijkt pagina 14 van 46
14
Running ARC Genesis
Before running ARC Genesis on a computer, connect the ARC microphone to your computer using the USB
cable it was supplied with, or another USB cable with the appropriate connections to connect the mic to
your computer.
To run ARC Genesis on a computer you will need to download the latest ARC Genesis software from
anthemarc.com. You will also need an ARC Genesis compatible microphone (available from your
MartinLogan dealer). When running ARC Genesis software we recommend Automatic Mode for most
users. This mode will walk you through the measurement process with step-by-step on screen instructions.
The ARC Genesis software’s Manual Mode is recommended for advanced users. For more information,
please visit anthemarc.com.
• Before running ARC Genesis, set up your subwoofers by adjusting placement.
• During measurement, ARC Genesis overrides the settings of the Volume (level), Phase, Low-Pass Filter,
and 20–30Hz Level controls. These controls do not impact the measurements. After the correction
curve has been uploaded to the subwoofer these controls can be used to fine tune the subwoofer’s
performance.
• When taking ARC Genesis measurements the microphone should be approximately at the locations
where your ears will be.
• When taking ARC Genesis measurements, the microphone should point up, towards the ceiling.
• When taking ARC Genesis measurements the room should be silent. Please turn off or remove potential
sources of noise.
• ARC Genesis will require you to measure five (or more) listening positions. The first position should be
located at the primary listening position. Subsequent measurements should be taken at other listening
positions and should be no closer than 2-feet from each other.
• Although it might seem logical to do so, you do not need to take measurements throughout the room
(i.e. in the front corners, far off to the side, etc.). Measurement locations should focus only on positions
where people will be listening to the subwoofer.
Bekijk gratis de handleiding van Martin Logan Dynamo 10, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Martin Logan |
| Model | Dynamo 10 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 3307 MB |
