Martin Exterior Projection Pro Compact handleiding

Niet gecategoriseerd

Martin

71 pagina's

PDF beschikbaar

Handleiding

Martin

Exterior Projection Pro Compact User Manual, Rev. A 29

Service and maintenance

Warning! Read the ‘Safety precautions’ chapter in the Safety and

Installation Manual included at the end of this User Manual before servicing

the fixture.

Important! Opening the fixture can allow moisture to enter and cause

condensation on the front glass. Read ‘Managing humidity’ below and

follow the guidelines in the fixture’s user documentation carefully.

Refer any service or repair operation not described in this manual to an authorized Martin service

technician. Do not try to carry out such an operation yourself, as doing so may present a health or

safety risk. It may also cause damage or malfunction, and it may void your product warranty.

Installation, on-site service and maintenance can be provided worldwide by the Martin Global Service

organization and its approved agents, giving owners access to Martin’s expertise and product

knowledge in a partnership that will ensure the highest level of performance throughout the product’s

lifetime. Please contact your Martin supplier for details.

Optical components have fragile coatings and are exposed to very high temperatures. Handle and

store components with care. Wear cotton gloves while handling them. Keep them perfectly clean and

free of oil and grease to reduce the risk of heat damage.

Cleaning

Regular cleaning is essential for fixture life and performance. Buildup of dust and dirt degrades the

fixture’s light output and cooling ability.

Cleaning schedules will vary greatly depending on the operating environment. It is therefore

impossible to specify precise cleaning intervals for the Exterior Projection Pro Compact. Inspect

fixtures within their first few weeks of operation to see whether cleaning is necessary. Check again at

frequent intervals. This procedure will allow you to assess cleaning requirements in your particular

situation. If in doubt, consult your Martin dealer about a suitable maintenance schedule.

Do not use products that contain solvents, abrasives or caustic agents for cleaning, as they can cause

surface damage to the fixture. The aluminum housing and front glass can be cleaned with mild

detergents such as those for washing cars.

To clean the housing and front glass:

1. Isolate the fixture from AC power and allow the fixture to cool for 20 minutes.

2. Visually check that the silicone seals and the power and data cables are in good condition. If any

seal or cable shows signs of damage, cracking or loss of water resistance, stop cleaning the

fixture and contact a Martin authorized service technician for replacement.

3. If seals are in good condition, rinse off loose dirt with a hose or low-pressure water spray.

4. Wash the aluminum housing and front glass using warm water with a little mild detergent and a

soft brush or sponge. Do not use abrasive cleaners.

5. Rinse with clean water and wipe dry.

Managing humidity

Martin Exterior Projection Pro Compact fixtures are IP66-rated and are designed to resist water and

moisture in environments with widely varying climate, temperature and humidity conditions. But if

fixtures are not managed correctly during installation and service, water and moisture can enter,

leading to humidity and condensation inside the fixtures. Maximize the performance and service life of

your product by following the precautions in this section.

Bekijk gratis de handleiding van Martin Exterior Projection Pro Compact, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.