Martin Audio WX3A handleiding
Handleiding
Je bekijkt pagina 8 van 17
6.3 WX3A - Sub Bass and Full Range/High Pass
Configuration (Stereo)
The WX3ASF plug-in board is used to control the W1, passive W2 and
passive W3 when operating either as stand-alone full-range systems or with
additional WS2 sub-bass enclosures.
It is also used to provide the outputs for other WX3A controllers configured
to drive active W2 and W3 systems used in stereo with WS2 sub-bass
enclosures.
PCB mounted jumper links on the plug-in board select various alignment
options for the full-range/high pass outputs (Bands 2 and 4). See Fig 6.
Fig. 6
If full-range mode (1) is selected, +6dB of low frequency boost at 65Hz is
applied to the full-range outputs (Bands 2 & 4).
If 100Hz high-pass crossover mode (2) is selected, the full-range outputs
are re-configured as 100Hz high-pass outputs.
In Overlap Mode (3), the sub-bass and full-range enclosures are allowed to
overlap and 3dB of LF boost is applied to the full-range enclosure. This
can be useful when the full-range systems are flown some distance from
the sub-bass. This mode allows some low frequency energy to be
reproduced by the flown loudspeakers without using up as much headroom
as would be required if the full-range +6dB low frequency boost were
applied.
Martin Audio – WX3A System Controller
ENGLISH
8
Mode 1
Mode 2
Mode 3
All material © 2007. Martin Audio Ltd. Subject to change without notice.
CONTENTS
<
>
PRINT
GUIDES
Bekijk gratis de handleiding van Martin Audio WX3A, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Martin Audio |
| Model | WX3A |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 2576 MB |
