Martin Audio MA900 handleiding
Handleiding
Je bekijkt pagina 14 van 19

Martin Audio – MA900 Amplifier
ENGLISH
14
10.1 Troubleshooting
These are typical things to check if you think your amplifier is faulty:
Fault: No output.
If the Signal Present LED (-40dB) is illuminating a signal is entering the amplifier and the likely cause is an
unsecured Speakon speaker connector, or loose termination.
Check also that the VHF protection is not activated. If it is, remove the cause of the possible high frequency
oscillations from the relevant input.
Fault: The amplifier goes into thermal protection when driven at low level.
Check that there is no short circuit present at the amplifier's output, e.g. any component in the loudspeaker (this
can occur when the speaker coil gets warm).
Fault: The amplifier goes into protection with power indicators off.
Check that the AC mains voltage is within the amplifier’s operating range, 130-265V @ 230V, and (65-135V @
115V). Over/under-voltage protection may have occurred. If the amplifier is connected by mistake to a 3-phase
supply, an internal non-resetable fuse or resistor may have blown. The amplifier then has to be returned to your
supplier for service.
Fault: The amplifier does not respond even after checking above items.
In the unlikely event of on a non-user rectifiable fault, return the amplifier to your supplier or an approved service
centre.
Martin Audio cannot be held responsible for damage or injury as a result of the top cover being removed.
All material © 2007. Martin Audio Ltd. Subject to change without notice.
<
>
PRINT
CONTENTS
GUIDES
Bekijk gratis de handleiding van Martin Audio MA900, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
Merk | Martin Audio |
Model | MA900 |
Categorie | Niet gecategoriseerd |
Taal | Nederlands |
Grootte | 3110 MB |