Martin Audio Engineer Remote handleiding
Handleiding
Je bekijkt pagina 24 van 80
Engineer 418 & 818 User Manual Page 24
Connecting RS-232
On the front of the device is the RS-232 port for remote control and configuration of the device with a PC with
the supplied Windows® Engineer software. To connect the Martin Audio Engineer to a PC use the supplied
RS232 cable only This cable is 1:1 connected, fully wired, one side fitted with a Male DB9 connector, other side
a Female DB9 connector. If a longer cable is required please observe that the maximum operational cable
length is typically 45 feet.
Warning: if the users’ PC uses a grounded power supply, make sure that the Martin Audio Engineer 418 and
the PC are on the same power distribution line to avoid data errors.
Connecting RS-485
On the rear of the device, next to the audio inputs, is the RS-485 port on a RJ-45 connector, used to connect
the Martin Audio Engineer 818 to the Martin Audio Engineer Remote or to an external third party control unit.
(e.g. Crestron/AMX). (For communication protocol please refer to the Engineer software manual)
The maximum operational cable length is typically 1000 ft. on CAT-5 (Unshielded Twisted Pairs) cable.
The RS-485 connection includes a+5V power line for powering the Engineer Remote. (Please refer to the wiring
scheme in the chapter “Engineer Remote”.)
Warning: if an external third party control unit is used with the RS-485 port, this device must have a double
isolated power supply.
Power Requirements
The Martin Audio Engineer 818 must be connected to a 100-240V AC 50-60Hz electrical power supply, with a
single phase, neutral and ground connection. Both the neutral and the phase of the power supply (building
fuse) need to be protected by a fuse with a maximum current of 16A. For safety reasons the Martin Audio
Engineer 818 must be connected to a properly grounded power outlet.
Always use the 3-pin IEC power cord supplied with the Martin Audio Engineer 818.
The power input fuse is located below the 3-pin IEC power input. Do not use a different type of fuse; always
replace a blown fuse with a compatible fuse.
Bekijk gratis de handleiding van Martin Audio Engineer Remote, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Martin Audio |
| Model | Engineer Remote |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 11493 MB |
