Martin Audio DX0.4 handleiding
Handleiding
Je bekijkt pagina 25 van 37
Output channels
To edit the output channels, use the output buttons on
the right of the front panel. These act as mute and edit
buttons. For details, see Front panel (page 8).
The output settings allow you to
▪ Achieve the best possible performance from your
speaker system.
▪ Minimise the possibility of damage due to excessive
sound levels.
To edit the output channels
1. Press and hold the appropriate output button until the
button goes blue and the channel menu appears. For
example, to edit channel one, press and hold button
1. If you've edited outputs before, the menu item
shown will be the menu item from last time.
2. To move through the menu, rotate PM1 to the left or
right.
3. To select a menu item, press PM1. An arrow → will
appear bottom left to show that you have selected the
item.
For information on each menu item, see the sections
below.
4. If you've selected a menu item, press PM2 to return
to the menu.
5. From the menu:
▪ To see the same setting on another output channel,
press and hold the other output channel button.
▪ To update another menu item, rotate PM1.
▪ To exit the menu, press PM2. The channel button
blue light will go out.
As soon as you make a change, the
DX0.4 saves the change. You don't need
to do a separate step to save changes.
Output channel menu
The output channel menu allows you to set up the
following:
▪ Name&FCP. See Output name (page 25) and
Resetting a channel to factory defaults (page 26)
▪ Source. See Output source (page 26)
▪ Gain. See Output gain (page 26)
▪ Polarity. See Output polarity (page 27)
▪ Delay. See Output delay (page 27)
▪ Peak Lim. See Peak limiter (page 27)
▪ Prog Lim. See Program limiter (page 27)
▪ FIR E/N. See Output FIR enable (page 28)
▪ HPF. See High pass filter (page 28)
▪ LPF. See Low pass filter (page 28)
▪ EQ E/N. See Enable output EQ (page 29)
▪ PEQ-01 to PEQ-08. See Eight band output EQ (page
29)
Output name
You can change each output channel name to anything
you like (up to six characters).
To change the output channel name
1. Press the appropriate output button 1 to 4 until the
button goes blue and the channel menu appears. For
details, see Output channels (page 25).
2. Changing input and output channel names is almost
identical, so use the instructions in Input name (page
21) starting at step 2.
The only difference is that for output channels, you
select Name+FCP rather than Name.
FCP is Factory Channel Preset. For
details, see Resetting a channel to
factory defaults (page 26).
DX0.4 User Guide
25
Bekijk gratis de handleiding van Martin Audio DX0.4, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Martin Audio |
| Model | DX0.4 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 4460 MB |
