Martin Audio Blackline F15 handleiding
Handleiding
Je bekijkt pagina 7 van 31
All material © 2007. Martin Audio Ltd. Subject to change without notice.
The F215
+
may be used with or without a system controller. For demanding applications, Martin Audio
recommends an M3
+
, DX1, DX2 or Engineer system controller configured to perform EQ and limiter
functions.
The M3
+
, DX1, DX2 or Engineer system controller may also be used to configure systems for additional
sub-bass cabinets – e.g. F215
+
+ S218
+
combinations.
3.3 3-way horn-loaded, full range systems
H3
+
and H3T
+
The Blackline H3
+
and H3T
+
are very high performance, vertically formatted, all-horn, three-way systems in
a single, wide-bandwidth package. They differ only in drive configuration. The H3
+
is bi-amplified whilst the
H3T
+
offers user selectable bi-amplified or tri-amplified modes.
New drivers have been developed for improved performance in all bands. The Hybrid™ low frequency
section comprises a horn-loaded 15” (380mm)/4” (100mm) voice coil driver that is reflex loaded to extend
the LF output to below the natural cut-off point of the horn.
The new LF driver features a water resistant cone and triple roll surround for increased excursion.
The H3
+
/H3T
+
mid horn has a unique ‘phase-ball’ loading device which maintains the constant directivity
characteristics of the horn at the upper end of its range. It is driven by a new 10” (250mm) midrange driver
with an aluminium demodulating ring for improved high-mid clarity and reduced distortion when driven hard.
The 70° x 40° H3
+
/H3T
+
HF section features a neodymium 1” (25mm) exit compression driver with a Kapton
diaphragm for high sensitivity and extended HF performance. The internal mid/high passive crossover
allows this three-way system to be driven in a bi-amp configuration.
The H3
+
is bi-amplified and must be used with a system controller. Martin Audio M3
+
, DX1, DX2 or
Engineer system controllers may be configured to provide the recommended 2-way crossover and limiter
functions.
Martin Audio DX1, DX2 or Engineer - or series connected M3
+
system controllers - may also be used to
configure H3
+
or H3T
+
systems for additional sub-bass cabinets – e.g. H3
+
+ S218
+
combinations.
The H3T
+
can be driven like an H3
+
when in bi-amplified mode. In tri-amplified mode the H3T
+
must be used
with a Martin Audio DX1, DX2 or Engineer system controllers to provide the recommended 3-way crossover
and limiter functions.
Bekijk gratis de handleiding van Martin Audio Blackline F15, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Martin Audio |
| Model | Blackline F15 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 5683 MB |
