Makita EM409MP handleiding
Handleiding
Je bekijkt pagina 15 van 316
15 ENGLISH
Lubricating moving parts
NOTICE: Follow the instruction of the fre-
quency and amount of grease supplied. Otherwise
insucient lubrication may damage moving parts.
Gear case:
CAUTION: Do not apply grease when the
gear case is hot. Hot gear case can cause burn
injury.
Apply grease (Shell Alvania 1 or 2, or equivalent) to the
gear case through the grease hole approximately every
30 working hours.
► Fig.19: 1. Grease hole
Drive axle:
Apply grease (Shell Alvania 1 or 2, or equivalent) to the
drive axle approximately every 30 working hours.
► Fig.20
NOTE: Genuine Makita grease may be purchased
from your local Makita dealer.
Replacing the nylon cord
WARNING: Use only the nylon cord with
diameter specied in this instruction manual.
Never use heavier line, metal wire, rope or the
like. Failure to do so may cause damage to the tool
and result in serious personal injury.
WARNING: Always remove the nylon cutting
head from the tool when replacing the nylon cord.
WARNING: Make sure that the cover of the
nylon cutting head is secured to the housing
properly as described in this instruction manual.
Failure to properly secure the cover may cause the
nylon cutting head to y apart resulting in serious
personal injury.
Replace the nylon cord if it is not fed any more. The
method of replacing the nylon cord varies depending on
the type of the nylon cutting head.
96-M10L
► Fig.21
Replacing the plastic blade
Replace the blade if it is worn out or broken.
► Fig.22
When installing the plastic blade, align the direction of
the arrow on the blade with that of the protector.
Storage
WARNING: Follow the warnings and precau-
tions in the chapter “SAFETY WARNINGS” and
the instruction manual of the power unit.
When storing the attachment separated from the power
unit, put the cap onto the end of the shaft.
► Fig.23
Interval of inspection and maintenance
Operating hour Before
Operation
Daily (10h) 30h
Whole unit Visually inspect for
damaged parts
- -
All xing screws and
nuts
Tighten
- -
Gear case Supply grease - -
Drive axle Supply grease - -
Cutter blade Visually inspect for
damage
-
Power unit Refer to the instruction manual of the power unit
Bekijk gratis de handleiding van Makita EM409MP, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Makita |
| Model | EM409MP |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 50057 MB |
