Makita DFJ214 handleiding
Handleiding
Je bekijkt pagina 11 van 76
11 ENGLISH
For model DFJ212 / DFJ213 / DFJ214 / DFV210
►Fig.12: 1. Power cable 2. Hole 3. Cable holder
7. (For DFJ212 / DFJ213 / DFJ214 / DFV210 only)
Close the zip fastener after installing or removing the
fan unit.
8. Connect the other end of the power cable to the
battery holder.
►Fig.13: 1. Battery holder
CAUTION: Always use the strip and snap
button to secure the fan unit to the jacket. If the
fanunitfalls,itmaycauseaninjury,ordamagetothe
fan unit.
Follow the installation procedure in reverse when
removing it.
Attaching the lter set
Optional accessory
Theltersetprotectsthefanunitfromdustandpowder.
Werecommendthatyouusetheltersetinadustyor
powdery work place.
Insertthelterattachmentbetweenthejacketandfan
unitasshowninthegure.
►Fig.14: 1. Ring 2.Holeinthejacket3. Filter attach-
ment 4. Fan unit 5. Filter
When tightening the ring, stop it at the mark near the
slot on the fan unit. After attaching the fan units, cover
thelterattachmentswithlters.
►Fig.15: 1. Mark 2. Slot
NOTICE: Make sure that the lter fully covers
the lter attachment. For better protection against
dust and powder, tuck the skirt of the lter
between the jacket and lter attachment.
FUNCTIONAL
DESCRIPTION
NOTICE: The fan jacket is effective when the
humidity and temperature of intake air are lower
than those of the body surface. The fan jacket
may not be effective if the air temperature and/or
humidity are higher than those inside the jacket.
Power button
Toturnonthejacket,pressandholdthepowerbutton
onthebatteryholder(optionalaccessory).Thejacket
starts at high air speed. Each time you tap the power
button, the air speed changes from high to medium,
medium to low, and low to high. The air speed indicator
shows the current air speed.
►Fig.16: 1. Air speed indicator 2. Power button
To turn off, press and hold the power button again.
Indicating the remaining battery capacity
Only for battery cartridges with the indicator
►Fig.17: 1. Indicator lamps 2. Check button
Press the check button on the battery cartridge to indi-
cate the remaining battery capacity. The indicator lamps
light up for a few seconds.
Indicator lamps Remaining
capacity
Lighted Off Blinking
75% to 100%
50% to 75%
25% to 50%
0% to 25%
(For 14.4 V and 18 V batteries only)
Charge the
battery.
(For 14.4 V and 18 V batteries only)
The battery
may have
malfunctioned.
NOTE: Depending on the conditions of use and the
ambient temperature, the indication may differ slightly
from the actual capacity.
Battery protection system
The device is equipped with a battery protection sys-
tem. This system automatically cuts off power to the
motor to extend battery life.
If the remaining battery capacity is too low, the device will not oper-
ate. When you turn the device on, the motor will run again, but stops
soon. In this situation, remove and recharge the battery cartridge.
Turbo button
Bypressingturbobuttononthebatteryholder,thejacket
works in turbo mode for quick cooling. Turbo mode lasts
for a minute and then air speed returns to normal.
►Fig.18: 1. Turbo button
Air ow
For DFJ210 / DFJ211 / DFJ310 / DFJ311 / DFJ410 /
DFJ411 only
Tomaintainastableairow,closethebuttonatthe
neckofthejacket.Fastenthebuttonontheribbonfor
betterairowintheback.
►Fig.19: 1. Ribbon
Airowinsidethejacketisshownbelow.
►Fig.20
Forajacketwithahood,wearthehoodoverahelmet.The
air from the fan goes through the helmet and cools your head.
►Fig.21
Bekijk gratis de handleiding van Makita DFJ214, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Makita |
| Model | DFJ214 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 11547 MB |
