Mabe MCL2040ESDG0 handleiding
Handleiding
Je bekijkt pagina 54 van 90
22
Troubleshooting
Washer Possible causes What to do
Too many
suds
Too much
detergent
Measure detergent carefully. Use less soap
if you have soft water, a smaller load, or a
lightly soiled load.
Using too much
detergent
Fill hoses or drain
hose is improperly
connected
Household drain
may be clogged
Constant pressure to
hoses at the water
source
Water leaks
Use less detergent. Use less soap if you
have soft water, a smaller load or a lightly
soiled load.
Make sure hose connections are tight at
faucets and washers are in place. Make
sure the end of the drain hose is correctly
inserted in and secured to drain facility.
Check household plumbing. You may
have to call a plumber.
Tighten hoses at the faucets and turn the
every 5 years.
Water
temperature
seems to be
incorrect
Waterpumped
outbefore cycle
is complete
Water leaks
Colder water
temperatures provide
better energy
Water supply is turned
connected
water valve are
clogged
House water heater is
not properly set
Lid lifted or cycle was
put in pause for over
24 hours
Drain hose is kinked or
improperly connected
New detergents were formulated to work
at lower water temperatures without
Turn hot and cold faucets completely on
and make sure hoses are connected to
correct faucets.
water connection hoses from the upper
back of the washer. Use a brush to clean
the washer valves. Reconnect the hoses
and turn the water back on.
Make sure the house water heater is
delivering water at 120°F–140°F
(48°C– 60°C).
Reset cycle.
Straighten drain hose and make sure
washer is not sitting on it. Top of drain
outlet should be less than 8 ft (2.5 m)
Bekijk gratis de handleiding van Mabe MCL2040ESDG0, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Mabe |
| Model | MCL2040ESDG0 |
| Categorie | Wasmachine |
| Taal | Nederlands |
| Grootte | 8937 MB |