Lofrans T1000 handleiding
Handleiding
Je bekijkt pagina 10 van 37
10
CAPSTANS
Problem Possible causes Solution
1. The capstan does
nor work when a
control is operated.
1.1 Protection switch in OFF
position
1.2 Lack of voltage in the system
1.3 Failure of the control box
1.4 Failure of the control
1.5 Failure of the electric motor
1.1 Check the protection switch and set it in the ON position
1.2 Check the charge status of the battery, check connections
1.3 Check and possibly replace the control box
1.4 Check and possibly replace the control
1.5 Measure the electric motor voltage; if it is OK, check the brushes
and clean them. If it does not work, replace the electric motor
2. The capstan runs
slowly and at times
jumps the circuit
breaker.
2.1 Section of cables not suitable.
2.2 Poor electrical connections.
2.3 Dirty brushes.
2.4 Water leaks in the electrical
engine.
2.5 There is no parallelism
between upper deck and
below deck.
2.6 The gearbox has lost oil.
2.7 The engine strains in one or
both directions.
2.8 The capstan works only in one
direction.
2.1 Increase the cable section
2.2 Check out the connections
2.3 Clean the brushes
2.4 Replace the electrical engine
2.5 Work surfaces and/or add shims to restore parallelism.
2.6 (SERVICE) Uninstall the gearbox and check out its condition.
Replace damaged parts after discovering the causes of the
leak. Also, replace gaskets and screws. Check out also the
engine condition, which may have been damaged during the
malfunction.
2.7 (SERVICE) Check out appropriately all connections of the power
cables. If they are alright, uninstall the engine (in some cases it
is convenient to disassemble also the gearbox). Check out and
possibly replace the brushes.
2.8 Check out on the control box that between B2-C and B3-C
contacts there are 12/24V when the espective buttons are
pressed. If this should happen and one of the relays does not
work, replace the control box.
3. The electric engine
runs but the shaft
does not rotate
either Up or Down
3.1 Heavy wear or breakage of
teeth of the crown / worm
screw.
3.2 Breakage of the engine
spindle.
3.1 (SERVICE) Uninstall the capstan and replace the broken parts.
Check out carefully that pieces or splinters of broken parts did
not enter into the oil circuit and have ruined other mechanical
parts. (*)
3.2 (SERVICE) Replacing of the engine. Care must be taken that
the broken part did not remain in the hole of the worm screw. (*)
(*) Take advantage of this opportunity to replace any other worn
parts, especially gaskets, screws, tabs, seeger, and oil.
4. On installation, it is
found that the shaft
and the studs are
short for a correct
coupling
4.1 The request referred to the
deck thickness was wrong.
4.1 If the key shaft works in the gearbox along all its length, the
xing studs can be adapted. Otherwise, a longer shaft must be
requested.
7 TROUBLESHOOTING
Bekijk gratis de handleiding van Lofrans T1000, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Lofrans |
| Model | T1000 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 3367 MB |
