Lofrans SX5 handleiding
Handleiding
Je bekijkt pagina 11 van 20
11
www.lofrans.com
Problem Possible causes Solution
1. The anchor
windlass does not
work when a control
is operated
1.1 Protection switch in OFF
position
1.2 Lack of voltage in the system
1.3 Failure of the control box
1.4 Failure of the control
1.5 Failure of the electric motor
1.1 Check the protection switch and set it in the ON position
1.2 Check the charge status of the battery, check connections
1.3 Check and possibly replace the control box
1.4 Check and possibly replace the control
1.5 Measure the electric motor voltage; if it is OK, check the brushes
and clean them. If it does not work, replace the electric motor
2. The chain jams
frequently
2.1 The chain locker is not deep
enough with respect to the
quantity of chain chosen
2.2 The chain is not suitable for
the gipsy
2.3 The chain is not calibrated
2.1 Position the anchor windlass in the deepest point of the chain
locker or reduce the quantity of chain
2.2 Change the gipsy
2.3 Check the chain: if it does not meet the tolerances, it must be
replaced
3. The anchor wind-
lass turns slowly
3.1 Unsuitable cable sections
3.2 Deck oors not parallel
3.3 Bad electrical connections
3.4 Dirty brushes
3.5 Water inltrations in the
electric motor
3.1 Increase cable section
3.2 Make oors parallel by interposing thicknesses
3.3 Check connections
3.4 Clean brushes
3.5 Replace the electric motor
4. The electric engine
runs but the shaft
does not rotate
either Up or Down
4.1 Heavy wear or breakage of
teeth of the crown / worm
screw.
4.2 Breakage of the engine
spindle.
4.1 (SERVICE) Uninstall the winch and replace the broken parts.
Check out carefully that pieces or splinters of broken parts did
not enter into the oil circuit and have ruined other mechanical
parts. (*)
4.2 (SERVICE) Replacing of the engine. Care must be taken that
the broken part did not remain in the hole of the worm screw. (*)
(*) Take advantage of this opportunity to replace any other worn
parts, especially gaskets, screws, tabs, seeger, and oil.
UK
1. By turning anticlockwise, remove the hand-wheel of the
gypsy through the manoeuvre handle.
2. Slip off from the shaft the upper clutch cone, the gipsy, and
the lower clutch cone.
3. Wash with running water. DO NOT USE WATER UNDER
PRESSURE.
4. Check that there is no evidence of corrosion or mechanical
stresses.
5. Reassemble by proceeding in the reverse order,
remembering to lubricate threads and all moving parts with
grease.
6.2 Gipsy maintenance/replacement
7 TROUBLESHOOTING
Lofrans'
Bekijk gratis de handleiding van Lofrans SX5, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Lofrans |
| Model | SX5 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 2846 MB |
